[PATCH v9 2/8] mtd: rawnand: rockchip: NFC drivers for RK3308, RK2928 and others

Miquel Raynal miquel.raynal at bootlin.com
Fri Oct 2 02:27:00 EDT 2020


Hi Yifeng,

Yifeng Zhao <yifeng.zhao at rock-chips.com> wrote on Tue, 29 Sep 2020
17:08:05 +0800:

> This driver supports Rockchip NFC (NAND Flash Controller) found on RK3308,
> RK2928, RKPX30, RV1108 and other SOCs. The driver has been tested using
> 8-bit NAND interface on the ARM based RK3308 platform.
> 
> Support Rockchip SoCs and NFC versions:
> - PX30 and RK3326(NFCv900).
> 	ECC: 16/40/60/70 bits/1KB.
> 	CLOCK: ahb and nfc.
> - RK3308 and RV1108(NFCv800).
> 	ECC: 16 bits/1KB.
> 	CLOCK: ahb and nfc.
> - RK3036 and RK3128(NFCv622).
> 	ECC: 16/24/40/60 bits/1KB.
> 	CLOCK: ahb and nfc.
> - RK3066, RK3188 and RK2928(NFCv600).
> 	ECC: 16/24/40/60 bits/1KB.
> 	CLOCK: ahb.
> 
> Supported features:
> - Read full page data by DMA.
> - Support HW ECC(one step is 1KB).
> - Support 2 - 32K page size.
> - Support 8 CS(depend on SoCs)
> 
> Limitations:
> - No support for the ecc step size is 512.
> - Untested on some SoCs.
> - No support for subpages.
> - No support for the builtin randomizer.
> - The original bad block mask is not supported. It is recommended to use
>   the BBT(bad block table).
> 
> Signed-off-by: Yifeng Zhao <yifeng.zhao at rock-chips.com>
> ---
> 
> Changes in v9:
> - The nfc->buffer will realloc while the page size of the second mtd
>   is large than the first one
> - Fix coding style.
> - Remove struct rk_nfc_clk.
> - Prepend some function with rk_nfc_.
> - Replace function readl_poll_timeout_atomic with readl_relaxed_poll_timeout.
> - Remove function rk_nfc_read_byte and rk_nfc_write_byte.
> - Don't select the die if 'check_only == true' in function rk_nfc_exec_op.
> - Modify function rk_nfc_write_page and rk_nfc_write_page_raw.

You should probably rebase your patches on a more recent kernel, there
are several inconsistencies with the current core (see the kernel test
robot reports). Please consider having a look at the history to follow
the naming. If you need help, please ask!

Cheers,
Miquèl



More information about the linux-mtd mailing list