[PATCH v14 06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP

[Tudor.Ambarus at microchip.com]

On 9/30/20 9:57 PM, Pratyush Yadav wrote:
> EXTERNAL EMAIL: Do not click links or open attachments unless you know the content is safe
> 
> The xSPI Profile 1.0 table specifies how many dummy cycles and address
> bytes are needed for the Read Status Register command in octal DTR mode.
> Use that information to send the correct Read SR command.
> 
> Signed-off-by: Pratyush Yadav <p.yadav at ti.com>

Reviewed-by: Tudor Ambarus <tudor.ambarus at microchip.com>

> ---
>  drivers/mtd/spi-nor/core.c | 10 ++++++++++
>  1 file changed, 10 insertions(+)
> 
> diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
> index 97e82a4821f6..1465cf80f978 100644
> --- a/drivers/mtd/spi-nor/core.c
> +++ b/drivers/mtd/spi-nor/core.c
> @@ -385,6 +385,11 @@ static int spi_nor_read_sr(struct spi_nor *nor, u8 *sr)
>                                    SPI_MEM_OP_NO_DUMMY,
>                                    SPI_MEM_OP_DATA_IN(1, sr, 0));
> 
> +               if (nor->reg_proto == SNOR_PROTO_8_8_8_DTR) {
> +                       op.addr.nbytes = nor->params->rdsr_addr_nbytes;
> +                       op.dummy.nbytes = nor->params->rdsr_dummy;
> +               }
> +
>                 spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
> 
>                 ret = spi_mem_exec_op(nor->spimem, &op);
> @@ -418,6 +423,11 @@ static int spi_nor_read_fsr(struct spi_nor *nor, u8 *fsr)
>                                    SPI_MEM_OP_NO_DUMMY,
>                                    SPI_MEM_OP_DATA_IN(1, fsr, 0));
> 
> +               if (nor->reg_proto == SNOR_PROTO_8_8_8_DTR) {
> +                       op.addr.nbytes = nor->params->rdsr_addr_nbytes;
> +                       op.dummy.nbytes = nor->params->rdsr_dummy;
> +               }
> +
>                 spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
> 
>                 ret = spi_mem_exec_op(nor->spimem, &op);
> --
> 2.28.0
>