[PATCH v8 3/6] spi: cadence-quadspi: Add multi-chipselect support for Intel LGM SoC

Vignesh Raghavendra vigneshr at ti.com
Thu Nov 19 07:57:09 EST 2020



On 11/19/20 11:25 AM, Ramuthevar,Vadivel MuruganX wrote:
> From: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar at linux.intel.com>
> 
> Add multiple chipselect support for Intel LGM SoCs,
> currently QSPI-NOR and QSPI-NAND supported.
> 
> Signed-off-by: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar at linux.intel.com>
> ---
>  drivers/spi/spi-cadence-quadspi.c | 15 +++++++++++++++
>  1 file changed, 15 insertions(+)
> 
> diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c
> index d12b765e87be..337778f75d5d 100644
> --- a/drivers/spi/spi-cadence-quadspi.c
> +++ b/drivers/spi/spi-cadence-quadspi.c
> @@ -38,6 +38,7 @@
>  
>  /* Capabilities */
>  #define CQSPI_SUPPORTS_OCTAL		BIT(0)
> +#define CQSPI_SUPPORTS_MULTI_CHIPSELECT BIT(1)
>  
>  struct cqspi_st;
>  
> @@ -75,6 +76,7 @@ struct cqspi_st {
>  	bool			is_decoded_cs;
>  	u32			fifo_depth;
>  	u32			fifo_width;
> +	u32			num_chipselect;
>  	bool			rclk_en;
>  	u32			trigger_address;
>  	u32			wr_delay;
> @@ -1049,6 +1051,7 @@ static int cqspi_of_get_flash_pdata(struct platform_device *pdev,
>  
>  static int cqspi_of_get_pdata(struct cqspi_st *cqspi)
>  {
> +	const struct cqspi_driver_platdata *ddata;

Unused variable?

>  	struct device *dev = &cqspi->pdev->dev;
>  	struct device_node *np = dev->of_node;
>  
> @@ -1070,6 +1073,14 @@ static int cqspi_of_get_pdata(struct cqspi_st *cqspi)
>  		return -ENXIO;
>  	}
>  
> +	ddata  = of_device_get_match_data(dev);
> +	if (ddata->hwcaps_mask & CQSPI_SUPPORTS_MULTI_CHIPSELECT) {

I don't see a need for this flag... Controller by default supports
multiple CS.

> +		if (of_property_read_u32(np, "num-cs", &cqspi->num_chipselect)) {
> +			dev_err(dev, "couldn't determine number of cs\n");
> +			return -ENXIO;
> +		}
> +	}
> +


Entire hunk can be replaced with:

        if (of_property_read_u32(np, "num-cs", &cqspi->num_chipselect))
		cqspi->num_chipselect = CQSPI_MAX_CHIPSELECT;


>  	cqspi->rclk_en = of_property_read_bool(np, "cdns,rclk-en");
>  
>  	return 0;
> @@ -1302,6 +1313,9 @@ static int cqspi_probe(struct platform_device *pdev)
>  	cqspi->current_cs = -1;
>  	cqspi->sclk = 0;
>  
> +	if (ddata->hwcaps_mask & CQSPI_SUPPORTS_MULTI_CHIPSELECT)
> +		master->num_chipselect = cqspi->num_chipselect;
> +

And then this becomes:
	master->num_chipselect = cqspi->num_chipselect;

>  	ret = cqspi_setup_flash(cqspi);
>  	if (ret) {
>  		dev_err(dev, "failed to setup flash parameters %d\n", ret);
> @@ -1391,6 +1405,7 @@ static const struct cqspi_driver_platdata am654_ospi = {
>  };
>  
>  static const struct cqspi_driver_platdata intel_lgm_qspi = {
> +	.hwcaps_mask = CQSPI_SUPPORTS_MULTI_CHIPSELECT,
>  	.quirks = CQSPI_DISABLE_DAC_MODE,
>  };
>  
> 



More information about the linux-mtd mailing list