[PATCH v2 1/2] mtd: rawnand: gpmi: Fix the driver only sense CS0 R/B issue
Han Xu
han.xu at nxp.com
Tue Dec 8 22:51:03 EST 2020
set the GPMI CTRL1 GANGED_RDYBUSY bit so dirver can sense the R/B signal
from all CS.
For the NAND chip MT29F64G08AFAAAWP, only the first chip detected
without the patch.
[ 3.764118] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0x68
[ 3.770613] nand: Micron MT29F64G08AFAAAWP
[ 3.774752] nand: 4096 MiB, SLC, erase size: 1024 KiB, page size: 8192, OOB size: 448
[ 3.786421] Bad block table found at page 524160, version 0x01
[ 3.792730] Bad block table found at page 524032, version 0x01
After applying the patch
[ 3.764445] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0x68
[ 3.770941] nand: Micron MT29F64G08AFAAAWP
[ 3.775080] nand: 4096 MiB, SLC, erase size: 1024 KiB, page size: 8192, OOB size: 448
[ 3.784390] nand: 2 chips detected
[ 3.790900] Bad block table found at page 524160, version 0x01
[ 3.796776] Bad block table found at page 1048448, version 0x01
Signed-off-by: Han Xu <han.xu at nxp.com>
---
drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c | 6 ++++--
drivers/mtd/nand/raw/gpmi-nand/gpmi-regs.h | 1 +
2 files changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
index 0d30f3fbb045..b06e202cdd0d 100644
--- a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
+++ b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
@@ -181,9 +181,11 @@ static int gpmi_init(struct gpmi_nand_data *this)
/*
* Decouple the chip select from dma channel. We use dma0 for all
- * the chips.
+ * the chips, force all NAND RDY_BUSY inputs to be sourced from
+ * RDY_BUSY0.
*/
- writel(BM_GPMI_CTRL1_DECOUPLE_CS, r->gpmi_regs + HW_GPMI_CTRL1_SET);
+ writel(BM_GPMI_CTRL1_DECOUPLE_CS | BM_GPMI_CTRL1_GANGED_RDYBUSY,
+ r->gpmi_regs + HW_GPMI_CTRL1_SET);
err_out:
pm_runtime_mark_last_busy(this->dev);
diff --git a/drivers/mtd/nand/raw/gpmi-nand/gpmi-regs.h b/drivers/mtd/nand/raw/gpmi-nand/gpmi-regs.h
index f5e4f26c34da..fc31fd084dcf 100644
--- a/drivers/mtd/nand/raw/gpmi-nand/gpmi-regs.h
+++ b/drivers/mtd/nand/raw/gpmi-nand/gpmi-regs.h
@@ -107,6 +107,7 @@
#define BV_GPMI_CTRL1_WRN_DLY_SEL_7_TO_12NS 0x2
#define BV_GPMI_CTRL1_WRN_DLY_SEL_NO_DELAY 0x3
+#define BM_GPMI_CTRL1_GANGED_RDYBUSY (1 << 19)
#define BM_GPMI_CTRL1_BCH_MODE (1 << 18)
#define BP_GPMI_CTRL1_DLL_ENABLE 17
--
2.17.1
More information about the linux-mtd
mailing list