[RESEND PATCH v3 5/8] mtd: spi-nor: cadence-quadspi: Handle probe deferral while requesting DMA channel

[Vignesh Raghavendra]

On 8/22/20 11:35 PM, Jan Kiszka wrote:
> On 01.06.20 09:04, Vignesh Raghavendra wrote:
>> dma_request_chan_by_mask() can throw EPROBE_DEFER if DMA provider
>> is not yet probed. Currently driver just falls back to using PIO mode
>> (which is less efficient) in this case. Instead return probe deferral
>> error as is so that driver will be re probed once DMA provider is
>> available.
>>
>> Signed-off-by: Vignesh Raghavendra <vigneshr at ti.com>
>> Reviewed-by: Tudor Ambarus <tudor.ambarus at microchip.com>
>> ---
[...]
>>
>>  static const struct spi_nor_controller_ops cqspi_controller_ops = {
>> @@ -1269,8 +1274,11 @@ static int cqspi_setup_flash(struct cqspi_st *cqspi, struct device_node *np)
>>  			dev_dbg(nor->dev, "using direct mode for %s\n",
>>  				mtd->name);
>>
>> -			if (!cqspi->rx_chan)
>> -				cqspi_request_mmap_dma(cqspi);
>> +			if (!cqspi->rx_chan) {
>> +				ret = cqspi_request_mmap_dma(cqspi);
>> +				if (ret == -EPROBE_DEFER)
>> +					goto err;
>> +			}
>>  		}
>>  	}
>>
>>
> 
> This seem to break reading the SPI flash on our IOT2050 [1] (didn't test
> the eval board yet).
> 
> Without that commit, read happens via PIO, and that works. With the
> commit, the pattern
> 
> with open("out.bin", "wb") as out:
>     pos = 0
>     while pos < 2:
>         with open("/dev/mtd0", "rb") as mtd:
>            mtd.seek(pos * 0x10000)
>            out.write(mtd.read(0x10000))
>         pos += 1
> 
> gives the wrong result for the second block while

Interesting... Could you please explain wrong result? Is the data move
around or completely garbage?

Does this fail even on AM654 EVM? Could you share full script for me to
test locally?

What is the flash on the board?

> 
> with open("out2.bin", "wb") as out:
>     with open("/dev/mtd0", "rb") as mtd:
>         out.write(mtd.read(0x20000))
> 
> (or "mtd_debug read") is fine.
> 
> What could be the reason? Our DTBs and k3-am654-base-board.dtb had some
> deviations /wrt the ospi node, but aligning ours to the base board made
> no difference.
> 
> Jan
> 
> [1] https://github.com/siemens/linux/commits/jan/iot2050
>