[PATCH v2 01/15] mtd: nand: Add max_bad_eraseblocks_per_lun info to memorg

Schrempf Frieder frieder.schrempf at kontron.de
Thu Jun 6 01:27:11 PDT 2019


Hi Emil,

On 04.06.19 10:01, Emil Lenngren wrote:
> Hi Miquel,
> 
>>   static const struct spinand_info macronix_spinand_table[] = {
>>          SPINAND_INFO("MX35LF1GE4AB", 0x12,
>> -                    NAND_MEMORG(1, 2048, 64, 64, 1024, 1, 1, 1),
>> +                    NAND_MEMORG(1, 2048, 64, 64, 1024, 40, 1, 1, 1),
>>                       NAND_ECCREQ(4, 512),
>>                       SPINAND_INFO_OP_VARIANTS(&read_cache_variants,
>>                                                &write_cache_variants,
>> @@ -103,7 +103,7 @@ static const struct spinand_info macronix_spinand_table[] = {
>>                       SPINAND_ECCINFO(&mx35lfxge4ab_ooblayout,
>>                                       mx35lf1ge4ab_ecc_get_status)),
>>          SPINAND_INFO("MX35LF2GE4AB", 0x22,
>> -                    NAND_MEMORG(1, 2048, 64, 64, 2048, 2, 1, 1),
>> +                    NAND_MEMORG(1, 2048, 64, 64, 2048, 20, 2, 1, 1),
>>                       NAND_ECCREQ(4, 512),
> 
> Maybe a bit late to the discussion, but shouldn't 20 and 40 be swapped
> here, i.e. isn't it the larger flash that has more max bad blocks than
> the smaller one?

I think Miquel is out of office for some days, so I just checked and you 
are right, the maximum number of bad blocks should be swapped.

Actually there is also a wrong value in the GigaDevice driver: For the 
GD5F4GQ4xA it should be 80 instead of 40.

Would you mind sending a patch with a "Fixes:" tag, that fixes both, the 
Macronix and the GigaDevice driver? Or should I send one?

Thanks,
Frieder


More information about the linux-mtd mailing list