[PATCH v3 4/4] dt-bindings: mfd: Document Macronix MX25F0A controller bindings

Mason Yang masonccyang at mxic.com.tw
Mon Apr 15 02:23:54 PDT 2019


Document the bindings used by the Macronix MX25F0A MFD controller.

Signed-off-by: Mason Yang <masonccyang at mxic.com.tw>
---
 .../devicetree/bindings/mfd/mxic-mx25f0a.txt       | 51 ++++++++++++++++++++++
 1 file changed, 51 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mfd/mxic-mx25f0a.txt

diff --git a/Documentation/devicetree/bindings/mfd/mxic-mx25f0a.txt b/Documentation/devicetree/bindings/mfd/mxic-mx25f0a.txt
new file mode 100644
index 0000000..7f3e0f8
--- /dev/null
+++ b/Documentation/devicetree/bindings/mfd/mxic-mx25f0a.txt
@@ -0,0 +1,51 @@
+Macronix MX25F0A MultiFunction Device Tree Bindings
+----------------------------------------------------
+
+MX25F0A is a MultiFunction Device with SPI and raw NAND, which
+supports either spi host controller or raw nand controller.
+
+Required properties:
+- compatible: should be "mxic,mx25f0a"
+- #address-cells: should be 1
+- #size-cells: should be 0
+- reg: should contain 2 entries, one for the registers and one for the direct
+       mapping area in SPI mode.
+- reg-names: should contain "regs" and "dirmap"
+- interrupts: interrupt line connected to this MFD controller
+- SPI controller driver:
+		- clock-names: should contain "ps_clk", "send_clk" and
+			       "send_dly_clk"
+		- clocks: should contain 3 entries for the "ps_clk", "send_clk"
+			  and "send_dly_clk" clocks
+
+- Raw nand controller driver.
+		- nand-ecc-mode = "soft";
+		- nand-ecc-algo = "bch";
+
+Example:
+
+	mxic: mx25f0a at 43c30000 {
+		compatible = "mxic,mx25f0a";
+		reg = <0x43c30000 0x10000>, <0xa0000000 0x4000000>;
+		reg-names = "regs", "dirmap";
+
+		/* spi */
+		clocks = <&clkwizard 0>, <&clkwizard 1>, <&clkc 15>;
+		clock-names = "send_clk", "send_dly_clk", "ps_clk";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		flash at 0 {
+			compatible = "jedec,spi-nor";
+			reg = <0>;
+			spi-max-frequency = <25000000>;
+			spi-tx-bus-width = <4>;
+			spi-rx-bus-width = <4>;
+		};
+
+		/* nand */
+		nand-ecc-mode = "soft";
+		nand-ecc-algo = "bch";
+		nand-ecc-step-size = <512>;
+		nand-ecc-strength = <8>;
+	};
-- 
1.9.1




More information about the linux-mtd mailing list