[PATCH v2 12/14] mtd: rawnand: qcom: check for operation errors in case of raw read

Abhishek Sahu absahu at codeaurora.org
Thu May 3 05:20:39 PDT 2018


Currently there is no error checking for raw read. For raw
reads, there won’t be any ECC failure but the operational
failures are possible so schedule the NAND_FLASH_STATUS read
after each codeword.

Signed-off-by: Abhishek Sahu <absahu at codeaurora.org>
---
* Changes from v1:

 1. Removed the code for copy_last_cw.

 drivers/mtd/nand/raw/qcom_nandc.c | 58 +++++++++++++++++++++++++++------------
 1 file changed, 40 insertions(+), 18 deletions(-)

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 10bdc6c..d828115 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -1099,7 +1099,8 @@ static void config_nand_page_read(struct qcom_nand_controller *nandc)
  * Helper to prepare DMA descriptors for configuring registers
  * before reading each codeword in NAND page.
  */
-static void config_nand_cw_read(struct qcom_nand_controller *nandc)
+static void
+config_nand_cw_read(struct qcom_nand_controller *nandc, bool use_ecc)
 {
 	if (nandc->props->is_bam)
 		write_reg_dma(nandc, NAND_READ_LOCATION_0, 4,
@@ -1108,19 +1109,25 @@ static void config_nand_cw_read(struct qcom_nand_controller *nandc)
 	write_reg_dma(nandc, NAND_FLASH_CMD, 1, NAND_BAM_NEXT_SGL);
 	write_reg_dma(nandc, NAND_EXEC_CMD, 1, NAND_BAM_NEXT_SGL);
 
-	read_reg_dma(nandc, NAND_FLASH_STATUS, 2, 0);
-	read_reg_dma(nandc, NAND_ERASED_CW_DETECT_STATUS, 1,
-		     NAND_BAM_NEXT_SGL);
+	if (use_ecc) {
+		read_reg_dma(nandc, NAND_FLASH_STATUS, 2, 0);
+		read_reg_dma(nandc, NAND_ERASED_CW_DETECT_STATUS, 1,
+			     NAND_BAM_NEXT_SGL);
+	} else {
+		read_reg_dma(nandc, NAND_FLASH_STATUS, 1, NAND_BAM_NEXT_SGL);
+	}
 }
 
 /*
  * Helper to prepare dma descriptors to configure registers needed for reading a
  * single codeword in page
  */
-static void config_nand_single_cw_page_read(struct qcom_nand_controller *nandc)
+static void
+config_nand_single_cw_page_read(struct qcom_nand_controller *nandc,
+				bool use_ecc)
 {
 	config_nand_page_read(nandc);
-	config_nand_cw_read(nandc);
+	config_nand_cw_read(nandc, use_ecc);
 }
 
 /*
@@ -1201,7 +1208,7 @@ static int nandc_param(struct qcom_nand_host *host)
 	nandc->buf_count = 512;
 	memset(nandc->data_buffer, 0xff, nandc->buf_count);
 
-	config_nand_single_cw_page_read(nandc);
+	config_nand_single_cw_page_read(nandc, false);
 
 	read_data_dma(nandc, FLASH_BUF_ACC, nandc->data_buffer,
 		      nandc->buf_count, 0);
@@ -1565,6 +1572,23 @@ struct read_stats {
 	__le32 erased_cw;
 };
 
+/* reads back FLASH_STATUS register set by the controller */
+static int check_flash_errors(struct qcom_nand_host *host, int cw_cnt)
+{
+	struct nand_chip *chip = &host->chip;
+	struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+	int i;
+
+	for (i = 0; i < cw_cnt; i++) {
+		u32 flash = le32_to_cpu(nandc->reg_read_buf[i]);
+
+		if (flash & (FS_OP_ERR | FS_MPU_ERR))
+			return -EIO;
+	}
+
+	return 0;
+}
+
 /*
  * reads back status registers set by the controller to notify page read
  * errors. this is equivalent to what 'ecc->correct()' would do.
@@ -1731,7 +1755,7 @@ static int read_page_ecc(struct qcom_nand_host *host, u8 *data_buf,
 			}
 		}
 
-		config_nand_cw_read(nandc);
+		config_nand_cw_read(nandc, true);
 
 		if (data_buf)
 			read_data_dma(nandc, FLASH_BUF_ACC, data_buf,
@@ -1841,7 +1865,7 @@ static int qcom_nandc_read_page_raw(struct mtd_info *mtd,
 			nandc_set_read_loc(nandc, 3, read_loc, oob_size2, 1);
 		}
 
-		config_nand_cw_read(nandc);
+		config_nand_cw_read(nandc, false);
 
 		read_data_dma(nandc, reg_off, data_buf, data_size1, 0);
 		reg_off += data_size1;
@@ -1860,12 +1884,13 @@ static int qcom_nandc_read_page_raw(struct mtd_info *mtd,
 	}
 
 	ret = submit_descs(nandc);
-	if (ret)
+	free_descs(nandc);
+	if (ret) {
 		dev_err(nandc->dev, "failure to read raw page\n");
+		return ret;
+	}
 
-	free_descs(nandc);
-
-	return ret;
+	return check_flash_errors(host, ecc->steps);
 }
 
 /* implements ecc->read_oob() */
@@ -2085,7 +2110,6 @@ static int qcom_nandc_block_bad(struct mtd_info *mtd, loff_t ofs)
 	struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
 	struct nand_ecc_ctrl *ecc = &chip->ecc;
 	int page, ret, bbpos, bad = 0;
-	u32 flash_status;
 	u8 *bbm_bytes_buf = chip->data_buf;
 
 	page = (int)(ofs >> chip->page_shift) & chip->pagemask;
@@ -2112,7 +2136,7 @@ static int qcom_nandc_block_bad(struct mtd_info *mtd, loff_t ofs)
 	 * bbpos offset.
 	 */
 	nandc_set_read_loc(nandc, 0, bbpos, host->bbm_size, 1);
-	config_nand_single_cw_page_read(nandc);
+	config_nand_single_cw_page_read(nandc, host->use_ecc);
 	read_data_dma(nandc, FLASH_BUF_ACC + bbpos, bbm_bytes_buf,
 		      host->bbm_size, 0);
 
@@ -2123,9 +2147,7 @@ static int qcom_nandc_block_bad(struct mtd_info *mtd, loff_t ofs)
 		goto err;
 	}
 
-	flash_status = le32_to_cpu(nandc->reg_read_buf[0]);
-
-	if (flash_status & (FS_OP_ERR | FS_MPU_ERR)) {
+	if (check_flash_errors(host, 1)) {
 		dev_warn(nandc->dev, "error when trying to read BBM\n");
 		goto err;
 	}
-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc.
is a member of Code Aurora Forum, hosted by The Linux Foundation




More information about the linux-mtd mailing list