[PATCH v2 8/9] atmel_flexcom: Support backup mode

Lee Jones lee.jones at linaro.org
Tue Sep 19 08:25:04 PDT 2017


On Tue, 19 Sep 2017, Nicolas Ferre wrote:

> On 15/09/2017 at 16:04, Romain Izard wrote:
> > The controller used by a flexcom module is configured at boot, and left
> > alone after this. As the configuration will be lost after backup mode,
> > restore the state of the flexcom driver on resume.
> > 
> > Signed-off-by: Romain Izard <romain.izard.pro at gmail.com>
> 
> Tested-by: Nicolas Ferre <nicolas.ferre at microchip.com>
> On sama5d2 Xplained board (i2c0 from flexcom 4).
> and obviously:
> Acked-by: Nicolas Ferre <nicolas.ferre at microchip.com>
> 
> Thanks Romain!
> 
> Regards,
> 
> > ---
> >  drivers/mfd/atmel-flexcom.c | 65 ++++++++++++++++++++++++++++++++++-----------
> >  1 file changed, 50 insertions(+), 15 deletions(-)

This is the first time I've seen this patch.  Why's that?

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog



More information about the linux-mtd mailing list