[PATCH v3 00/37] mtd: nand: denali: 2nd round of Denali NAND IP patch bomb
Masahiro Yamada
yamada.masahiro at socionext.com
Wed Mar 29 23:45:46 PDT 2017
This driver includes many problems.
One of the biggest one is a bunch of hard-coded parameters. This IP
has many parameters that can be customized when a delivery RTL is
generated. However, this driver was upstreamed by Intel, with
Intel parameters hard-coded. Later, Altera added denali_dt.c to use
this driver for embedded boards, but they did not fix the code in
denali.c So, this driver has never worked. Even some DT bindings
actually turned out wrong.
There are more problems: [1] The driver just retrieves the OOB area as-is
whereas the controller uses syndrome page layout. [2] Many NAND chip
specific parameters are hard-coded in the driver. [3] ONFi devices are
not working [4] It can not read Bad Block Marker
This patch series intends to solve those problems.
Outstanding changes are:
- Fix raw/oob callbacks for syndrome page layout
- Implement setup_data_interface() callback
- Fix/implement more commands for ONFi devices
- Allow to skip the driver internal bounce buffer
- Support PIO in case DMA is not supported
- Switch from ->cmdfunc over to ->cmd_ctrl
18 patches were merged at v2.
Here is the rest of the series.
v1: https://lkml.org/lkml/2016/11/26/144
v2: https://lkml.org/lkml/2017/3/22/804
Masahiro Yamada (37):
mtd: nand: relax ecc.read_page() return value for uncorrectable ECC
mtd: nand: denali: allow to override mtd->name from label DT property
mtd: nand: denali: remove meaningless pipeline read-ahead operation
mtd: nand: denali: fix bitflips calculation in handle_ecc()
mtd: nand: denali: fix erased page checking
mtd: nand: denali: support HW_ECC_FIXUP capability
mtd: nand: denali_dt: enable HW_ECC_FIXUP for Altera SOCFPGA variant
mtd: nand: denali: support 64bit capable DMA engine
mtd: nand: denali_dt: remove dma-mask DT property
mtd: nand: denali_dt: use pdev instead of ofdev for platform_device
mtd: nand: denali: allow to override revision number
mtd: nand: denali: support 1024 byte ECC step size
mtd: nand: denali: avoid hard-coding ecc.strength and ecc.bytes
mtd: nand: denali: support "nand-ecc-strength" DT property
mtd: nand: denali: remove Toshiba and Hynix specific fixup code
mtd: nand: denali_dt: add compatible strings for UniPhier SoC variants
mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS
mtd: nand: denali: do not propagate NAND_STATUS_FAIL to waitfunc()
mtd: nand: denali: use BIT() and GENMASK() for register macros
mtd: nand: denali: remove unneeded find_valid_banks()
mtd: nand: denali: handle timing parameters by setup_data_interface()
mtd: nand: denali: rework interrupt handling
mtd: nand: denali: fix NAND_CMD_STATUS handling
mtd: nand: denali: fix NAND_CMD_PARAM handling
mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc
mtd: nand: denali: fix bank reset function
mtd: nand: denali: use interrupt instead of polling for bank reset
mtd: nand: denali: propagate page to helpers via function argument
mtd: nand: denali: merge struct nand_buf into struct denali_nand_info
mtd: nand: denali: use flag instead of register macro for direction
mtd: nand: denali: fix raw and oob accessors for syndrome page layout
mtd: nand: denali: support hardware-assisted erased page detection
mtd: nand: allocate aligned buffers if NAND_OWN_BUFFERS is unset
mtd: nand: allow drivers to request minimum alignment for passed
buffer
mtd: nand: denali: skip driver internal bounce buffer when possible
mtd: nand: denali: use non-managed kmalloc() for DMA buffer
mtd: nand: denali: enable bad block table scan
.../devicetree/bindings/mtd/denali-nand.txt | 24 +-
drivers/mtd/nand/denali.c | 1971 ++++++++++----------
drivers/mtd/nand/denali.h | 308 +--
drivers/mtd/nand/denali_dt.c | 90 +-
drivers/mtd/nand/denali_pci.c | 10 +-
drivers/mtd/nand/nand_base.c | 49 +-
include/linux/mtd/nand.h | 4 +-
7 files changed, 1234 insertions(+), 1222 deletions(-)
--
2.7.4
More information about the linux-mtd
mailing list