[PATCH v5 00/23] mtd: nand: denali: Denali NAND IP patch bomb
Masahiro Yamada
yamada.masahiro at socionext.com
Wed Jun 7 23:16:53 PDT 2017
Hi Boris,
2017-06-07 20:52 GMT+09:00 Masahiro Yamada <yamada.masahiro at socionext.com>:
> This patch series intends to solve various problems.
>
> [1] The driver just retrieves the OOB area as-is
> whereas the controller uses syndrome page layout.
> [2] Many NAND chip specific parameters are hard-coded in the driver.
> [3] ONFi devices are not working
> [4] It can not read Bad Block Marker
>
> Outstanding changes are:
> - Fix raw/oob callbacks for syndrome page layout
> - Implement setup_data_interface() callback
> - Fix/implement more commands for ONFi devices
> - Allow to skip the driver internal bounce buffer
> - Support PIO in case DMA is not supported
> - Switch from ->cmdfunc over to ->cmd_ctrl
I am planning v6, but
how many can you pick-up from this series?
I did not see your comments for 01-05, so are they applicable?
Could you add
Acked-by: Rob Herring <robh at kernel.org>
for 05 (http://patchwork.ozlabs.org/patch/772388/)
He had already acked it, but I just missed it.
--
Best Regards
Masahiro Yamada
More information about the linux-mtd
mailing list