[PATCH 01/14] qcom: mtd: nand: Add driver data for QPIC DMA

[Boris Brezillon]

On Mon, 17 Jul 2017 11:41:01 +0530
Abhishek Sahu <absahu at codeaurora.org> wrote:

> >> > +
> >> > +nand at 79b0000 {  
> > 
> > nand-controller at xxxx {
> > 
> > BTW, glad to see another driver moving to the new DT representation 
> > :-).
> >   
> >> > +	compatible = "qcom,qpic-nandc-v1.4.0";
> >> > +	reg = <0x79b0000 0x1000>;
> >> > +
> >> > +	clocks = <&gcc GCC_QPIC_CLK>,
> >> > +		<&gcc GCC_QPIC_AHB_CLK>;
> >> > +	clock-names = "core", "aon";
> >> > +
> >> > +	#address-cells = <1>;
> >> > +	#size-cells = <0>;
> >> > +
> >> > +	nandcs at 0 {  
> > 
> > 	nand at 0 {
> >   
> >> > +		compatible = "qcom,nandcs";  
> > 
> > Why do you need a compatible here?  
> It is the part of original driver. We can connect multiple
> NAND devices in the same bus and qcom,nandcs is being used
> for each connected NAND device. Each NAND device can use
> different  chip select, ecc strength etc which we can specify
> under this sub node.


Still don't understand why you need a compatible? Is this a memory bus
where you can connect other kind of memories (parallel NORs,
SRAMs, ...)?

If that's not the case, then considering all subnodes of the
nand-controller node containing a reg property as NAND devices is fine,
you don't need this compatible = "nand,cs" (see sunxi-nand bindings
[1]).

If the bus is generic and can be attached non-NAND devices, I'd
recommend looking at atmel's binding [2], because you're likely to
have one instance of the NAND controller logic for all NAND devices
connected on this bus.
And more importantly, if the bus a generic, the node should not be
named nand or nand-controller, and the compatible should not contain
'nandc' in it.

[1]http://elixir.free-electrons.com/linux/latest/source/Documentation/devicetree/bindings/mtd/sunxi-nand.txt#L34
[2]http://elixir.free-electrons.com/linux/latest/source/Documentation/devicetree/bindings/mtd/atmel-nand.txt#L70