[PATCH v7 10/16] reset: Add a reset controller driver for the Lantiq XWAY based SoCs

[Andy Shevchenko]

On Mon, Jul 3, 2017 at 1:40 AM, Hauke Mehrtens <hauke at hauke-m.de> wrote:
> From: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
>
> The reset controllers (on xRX200 and newer SoCs have two of them) are
> provided by the RCU module. This was initially implemented as a simple
> reset controller. However, the RCU module provides more functionality
> (ethernet GPHYs, USB PHY, etc.), which makes it a MFD device.
> The old reset controller driver implementation from
> arch/mips/lantiq/xway/reset.c did not honor this fact.
>
> For some devices the request and the status bits are different.

> +Required properties:
> +- compatible           : Should be one of
> +                               "lantiq,danube-reset"
> +                               "lantiq,xrx200-reset"
> +- offset-set           : Offset of the reset set register
> +- offset-status                : Offset of the reset status register

Just one side comment (I'm fine with either choice, just for your
information). Recently I have reviewed at24 patch which adds a
property for getting MAC offset and my reseach ends up with the naming
pattern mac-offset (as many others are doing this way). So, perhaps in
your case it might make sense to do that way? Anyway, it's a matter of
a (bit of a) chaos in DT bindings, whatever you decide users will live
with.

-- 
With Best Regards,
Andy Shevchenko