[PATCH, 1/2] mtd: m25p80: Let m25p80_read() fallback to spi transfer

[Michal Suchanek]

On 25 January 2017 at 03:08, Marek Vasut <marex at denx.de> wrote:
> On 01/24/2017 12:41 AM, Kamal Dasu wrote:
>> "ret can never be > 0 , it is only 0 or negative "
>>
>> I can fix this.
>>
>>>>> This looks really fragile and special-casing EINVAL here doesn't scale.
>>>>> But still, if your controller driver is buggy, fix the driver, do not
>>>>> pollute core code with workarounds. If you do support this sort of
>>>>> accelerated read and it fails, it means something is seriously wrong.
>>>>> If you need to invoke regular SPI reads to complete under some obscure
>>>>> circumstances, do it from the driver, not here.
>>>>
>>>> I guess the other half of m25p80_read can be factored out and used as
>>>> fallback from either m25p80_read or the controller driver.
>>>
>>> I think I see what you mean, but care to show an RFC patch ?
>>>
>>> --
>>
>> Its not the controller driver, but he hardware limitation with older
>> controller version. I have tried to see how I can do this better,
>> however when spi_flash_read() is called  cannot handle it within my
>> driver without returning from the function. I went over this with Mark
>> previously and this current solution seemed reasonable. Any other
>> solution outside of the generic driver would replicate a lot of code
>> unnecessarily.
>
> Hmmm, I kinda see the problem. I was thinking splitting the m25p80_read
> function could be the solution and invoking the second part from the
> driver if applicable, but this cannot work because the driver does not
> know when it's interacting with SPI NOR and when with something else .
>
> Can you tell me about the conditions under which the bcm controller
> fails and should fall back to standard spi read ?

spi_flash_read is designed to perform what m25p80_read does in a
controller-specific way. So how can you get to a point when you are
in spi_flash_read, it fails, and you do not know you if you can call
the bottom half of m25p80_read to finish the job?

Thanks

Michal