[PATCH] mtd: nand: gpio: make nCE GPIO optional

[Christophe LEROY]

Le 13/02/2017 à 11:30, Boris Brezillon a écrit :
> On Fri, 10 Feb 2017 15:01:10 +0100 (CET)
> Christophe Leroy <christophe.leroy at c-s.fr> wrote:
>
>> On some hardware, the nCE signal is wired to the ChipSelect associated
>> to bus address of the NAND, so it is automatically driven during the
>> memory access and it is not managed by a GPIO.
>
> Hm, I'm not sure how this can work, because, AFAIR, the nCE line needs
> to stay low for the whole CMD+ADDR[+CMD] cycle, and with your patch
> it's not guaranteed.

Anyway, the patch just makes it possible to register the device 
allthough nCE GPIO is not defined.
For people defining the nCE GPIO properly, the patch introduces no 
change at all.

>
> Can you tell us more about your NAND controller?

[    0.498490] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xda
[    0.504906] nand: Micron MT29F2G08ABAEAWP
[    0.508918] nand: 256 MiB, SLC, erase size: 128 KiB, page size: 2048, 
OOB size: 64

Diagrams on datasheet shows that CE\ can optionnaly go up between each 
access. See attached exemple.



>
>>
>> Signed-off-by: Christophe Leroy <christophe.leroy at c-s.fr>
>> ---
>>  drivers/mtd/nand/gpio.c | 18 ++++++++++++------
>>  1 file changed, 12 insertions(+), 6 deletions(-)
>>
>> diff --git a/drivers/mtd/nand/gpio.c b/drivers/mtd/nand/gpio.c
>> index 0d24857..85294f1 100644
>> --- a/drivers/mtd/nand/gpio.c
>> +++ b/drivers/mtd/nand/gpio.c
>> @@ -78,7 +78,9 @@ static void gpio_nand_cmd_ctrl(struct mtd_info *mtd, int cmd, unsigned int ctrl)
>>  	gpio_nand_dosync(gpiomtd);
>>
>>  	if (ctrl & NAND_CTRL_CHANGE) {
>> -		gpio_set_value(gpiomtd->plat.gpio_nce, !(ctrl & NAND_NCE));
>> +		if (gpio_is_valid(gpiomtd->plat.gpio_nce))
>> +			gpio_set_value(gpiomtd->plat.gpio_nce,
>> +				       !(ctrl & NAND_NCE));
>>  		gpio_set_value(gpiomtd->plat.gpio_cle, !!(ctrl & NAND_CLE));
>>  		gpio_set_value(gpiomtd->plat.gpio_ale, !!(ctrl & NAND_ALE));
>>  		gpio_nand_dosync(gpiomtd);
>> @@ -201,7 +203,8 @@ static int gpio_nand_remove(struct platform_device *pdev)
>>
>>  	if (gpio_is_valid(gpiomtd->plat.gpio_nwp))
>>  		gpio_set_value(gpiomtd->plat.gpio_nwp, 0);
>> -	gpio_set_value(gpiomtd->plat.gpio_nce, 1);
>> +	if (gpio_is_valid(gpiomtd->plat.gpio_nce))
>> +		gpio_set_value(gpiomtd->plat.gpio_nce, 1);
>>
>>  	return 0;
>>  }
>> @@ -239,10 +242,13 @@ static int gpio_nand_probe(struct platform_device *pdev)
>>  	if (ret)
>>  		return ret;
>>
>> -	ret = devm_gpio_request(&pdev->dev, gpiomtd->plat.gpio_nce, "NAND NCE");
>> -	if (ret)
>> -		return ret;
>> -	gpio_direction_output(gpiomtd->plat.gpio_nce, 1);
>> +	if (gpio_is_valid(gpiomtd->plat.gpio_nce)) {
>> +		ret = devm_gpio_request(&pdev->dev, gpiomtd->plat.gpio_nce,
>> +					"NAND NCE");
>> +		if (ret)
>> +			return ret;
>> +		gpio_direction_output(gpiomtd->plat.gpio_nce, 1);
>> +	}
>>
>>  	if (gpio_is_valid(gpiomtd->plat.gpio_nwp)) {
>>  		ret = devm_gpio_request(&pdev->dev, gpiomtd->plat.gpio_nwp,
-------------- next part --------------
A non-text attachment was scrubbed...
Name: read_status_cycle.png
Type: image/png
Size: 21577 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-mtd/attachments/20170213/5dd236ef/attachment-0001.png>