[PATCH 1/2] dt-bindings: mtd: Altera ASMI Parallel II IP Core

[matthew.gerlach at linux.intel.com]

Hi Rob,

Thanks for the feedback.  Please see my comments in line.

Matthew Gerlach

On Thu, 10 Aug 2017, Rob Herring wrote:

> On Sun, Aug 06, 2017 at 11:24:02AM -0700, matthew.gerlach at linux.intel.com wrote:
>> From: Matthew Gerlach <matthew.gerlach at linux.intel.com>
>>
>> Device Tree bindinds for Altera ASMI Parallel II IP Core.
>
> s/bindinds/bindings/
>
>>
>> Signed-off-by: Matthew Gerlach <matthew.gerlach at linux.intel.com>
>> ---
>>  .../devicetree/bindings/mtd/altera-asmip2.txt      | 22 ++++++++++++++++++++++
>>  1 file changed, 22 insertions(+)
>>  create mode 100644 Documentation/devicetree/bindings/mtd/altera-asmip2.txt
>>
>> diff --git a/Documentation/devicetree/bindings/mtd/altera-asmip2.txt b/Documentation/devicetree/bindings/mtd/altera-asmip2.txt
>> new file mode 100644
>> index 0000000..3380366
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/mtd/altera-asmip2.txt
>> @@ -0,0 +1,22 @@
>> +* Altera ASMI Parallel II IP Core
>> +
>> +Required properties:
>> +- compatible : Should be "altr,asmi_parallel2".
>
> s/_/-/
>
>> +- reg : A tuple consisting of a physical address and length.
>> +
>> +Optional subnodes:
>> +Subnodes of the Altera ASMI Paralllel II IP Core are spi slave nodes.
>
> But this is not a general purpose SPI controller?


The component is a general pupose SPI controller, but this driver
expects a spi-nor device to be connected to it.  As such I wonder if the
compatible string should be "altr,asmi-parallel2-spi-nor".


>
>> +- reg : chip select value
>> +- label : optional user friendly label
>> +
>> +Example:
>> +
>> +qspi: spi at a0001000 {
>> +	compatible = "altr,asmi_parallel2";
>> +	reg = <0xa0001000 0x10>;
>> +
>> +	flash at 0 {
>
> This should have a compatible.
>
>> +		reg = <0>;
>> +		label = "FPGA Image";
>> +	};

Since I have no way to test multiple flash chips, it might
be simpler to not specify any subnodes.

>> +};
>> --
>> 2.7.4
>>
>