[PATCH] mtd: spi-nor: cqspi: fix error return code in cqspi_probe()

[Marek Vasut]

On 08/09/2017 06:22 PM, Gustavo A. R. Silva wrote:
> platform_get_irq() returns an error code, but the cadence-quadspi
> driver ignores it and always returns -ENXIO. This is not correct
> and, prevents -EPROBE_DEFER from being propagated properly.
> 
> Print and propagate the return value of platform_get_irq on failure.
> 
> This issue was detected with the help of Coccinelle.
> 
> Signed-off-by: Gustavo A. R. Silva <gustavo at embeddedor.com>
> ---
>  drivers/mtd/spi-nor/cadence-quadspi.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
> index 53c7d8e..15dacf5 100644
> --- a/drivers/mtd/spi-nor/cadence-quadspi.c
> +++ b/drivers/mtd/spi-nor/cadence-quadspi.c
> @@ -1202,8 +1202,8 @@ static int cqspi_probe(struct platform_device *pdev)
>  	/* Obtain IRQ line. */
>  	irq = platform_get_irq(pdev, 0);
>  	if (irq < 0) {
> -		dev_err(dev, "Cannot obtain IRQ.\n");
> -		return -ENXIO;
> +		dev_err(dev, "Cannot obtain IRQ: %d\n", irq);

"Cannot obtain IRQ, ret=%i\n" please . It's inobvious what the value
means otherwise.

> +		return irq;
>  	}
>  
>  	ret = clk_prepare_enable(cqspi->clk);
> 


-- 
Best regards,
Marek Vasut