[PATCH v2 02/25] mtd: nand: qcom: program NAND_DEV_CMD_VLD register

Abhishek Sahu absahu at codeaurora.org
Thu Aug 3 10:59:51 PDT 2017


On 2017-08-03 21:17, Boris Brezillon wrote:
> On Wed, 19 Jul 2017 17:17:50 +0530
> Abhishek Sahu <absahu at codeaurora.org> wrote:
> 
>> The current driver is failing without complete bootchain since
>> NAND_DEV_CMD_VLD value is not valid.
>> 
>> Signed-off-by: Abhishek Sahu <absahu at codeaurora.org>
>> ---
>>  drivers/mtd/nand/qcom_nandc.c | 4 ++++
>>  1 file changed, 4 insertions(+)
>> 
>> diff --git a/drivers/mtd/nand/qcom_nandc.c 
>> b/drivers/mtd/nand/qcom_nandc.c
>> index bc0408c..f3b995d 100644
>> --- a/drivers/mtd/nand/qcom_nandc.c
>> +++ b/drivers/mtd/nand/qcom_nandc.c
>> @@ -148,6 +148,9 @@
>>  #define	FETCH_ID			0xb
>>  #define	RESET_DEVICE			0xd
>> 
>> +/* Value for NAND_DEV_CMD_VLD */
>> +#define NAND_DEV_CMD_VLD_VAL		0x1d
> 
> Where does this 0x1d value comes from? Defining a macro instead of
> passing 0x1d does not change the fact that this is a magic value :-).
> 

  This register tells the NAND controller which commands are valid

  Bits    Meaning
  0       READ_START_VALID
  1       READ_STOP_VALID
  2       WRITE_START_VALID
  3       ERASE_START_VALID
  4       SEQ_READ_START_VLD

  The default power on value is
  0xe - ERASE_START_VALID | WRITE_START_VALID | READ_STOP_VALID

  It need to be programmed for
  0x1d - READ_START_VALID | WRITE_START_VALID | ERASE_START_VALID | 
SEQ_READ_START_VLD

  Read STOP command is not required in normal NAND reads so it need to be 
disabled.

  I will define the individual bits and will make this value with bits 
which will
  make this more clear.

>> +
>>  /*
>>   * the NAND controller performs reads/writes with ECC in 516 byte 
>> chunks.
>>   * the driver calls the chunks 'step' or 'codeword' interchangeably
>> @@ -1972,6 +1975,7 @@ static int qcom_nandc_setup(struct 
>> qcom_nand_controller *nandc)
>>  {
>>  	/* kill onenand */
>>  	nandc_write(nandc, SFLASHC_BURST_CFG, 0);
>> +	nandc_write(nandc, NAND_DEV_CMD_VLD, NAND_DEV_CMD_VLD_VAL);
>> 
>>  	/* enable ADM DMA */
>>  	nandc_write(nandc, NAND_FLASH_CHIP_SELECT, DM_EN);

-- 
Abhishek Sahu



More information about the linux-mtd mailing list