[PATCH v3 12/37] mtd: nand: denali: support 1024 byte ECC step size

[Masahiro Yamada]

2017-03-30 15:45 GMT+09:00 Masahiro Yamada <yamada.masahiro at socionext.com>:
> This driver was originally written for the Intel MRST platform with
> several platform specific parameters hard-coded.  Another thing we
> need to fix is the hard-coded ECC step size.  Currently, it is
> defined as follows:
>
>   #define ECC_SECTOR_SIZE 512
>
> (somehow, it is defined in both denali.c and denali.h)
>
> This must be avoided because the Denali IP supports 1024B ECC size
> as well.  The Denali User's Guide also says supporting both 512B and
> 1024B ECC sectors is possible, though it would require instantiation
> of two different ECC circuits.  So, possible cases are:
>
>  [1] only 512B ECC size is supported
>  [2] only 1024B ECC size is supported
>  [3] both 512B and 1024B ECC sizes are supported
>
> Newer versions of this IP need ecc.size and ecc.steps explicitly
> set up via the following registers:
>   CFG_DATA_BLOCK_SIZE       (0x6b0)
>   CFG_LAST_DATA_BLOCK_SIZE  (0x6c0)
>   CFG_NUM_DATA_BLOCKS       (0x6d0)
>
> Older versions do not have such registers (they were reserved), so
> write accesses are safely ignored.
>
> This commit adds new flags DENALI_CAP_ECC_SIZE_{512,1024}.
>
> The DT property "nand-ecc-step-size" is still optional; a reasonable
> default will be chosen for [1] and [2].  For case [3], users can
> force ECC size via DT in case firmware hard-codes ECC settings.
> If not specified, the driver will use chip's ECC requirement as a
> hint to decide the ECC size.
>
> Signed-off-by: Masahiro Yamada <yamada.masahiro at socionext.com>
> Acked-by: Rob Herring <robh at kernel.org>
> ---
>
> Changes in v3:
>   - Move DENALI_CAP_ define out of struct denali_nand_info
>   - Use chip->ecc_step_ds as a hint to choose chip->ecc.size
>     where possible
>


Please hold back this patch
until we decide how to handle 14.




-- 
Best Regards
Masahiro Yamada