[PATCH 0/2] mtd: nand: Enforce tCCS wait time after a column change

[Boris Brezillon]

On Sat,  1 Oct 2016 10:24:01 +0200
Boris Brezillon <boris.brezillon at free-electrons.com> wrote:

> Hi,
> 
> Marc recently struggled with the RNDIN/RNDOUT commands when trying to
> add support for the Tango NAND controller.
> After some investigation it appeared that nothing in the
> nand_command_lp() code waits tCCS, which is required to make sure the
> NAND chip is ready to receive/send data on the bus after a column
> change.
> 
> This series adds some more timings to the nand_sdr_timings struct
> (including tCCS) and try to extract them from the ONFI parameter table
> (if available).
> 
> It then adds a new flags to ask the core to enforce the tCCS
> constraint.
> As noted in the commit message, this is an opt-in flag to avoid perf
> regressions on existing implementations (adding an ndelay() might be
> useless if the controller IP or driver already takes care of that),
> but it might appear that some implementations are actually broken and
> needs this flag as well.

Applied.

> 
> Regards,
> 
> Boris
> 
> Boris Brezillon (2):
>   mtd: nand: Add a few more timings to nand_sdr_timings
>   mtd: nand: Wait tCCS after a column change
> 
>  drivers/mtd/nand/nand_base.c    | 26 +++++++++++++++++++++++++-
>  drivers/mtd/nand/nand_timings.c | 26 +++++++++++++++++++++++++-
>  include/linux/mtd/nand.h        | 18 ++++++++++++++++++
>  3 files changed, 68 insertions(+), 2 deletions(-)
>