[v7, 1/3] nand: pl353: Add basic driver for arm pl353 smc nand interface

Jason Gunthorpe jgunthorpe at obsidianresearch.com
Fri Oct 21 13:33:22 PDT 2016


On Mon, Jun 08, 2015 at 11:38:36PM +0530, Punnaiah Choudary Kalluri wrote:
> Add driver for arm pl353 static memory controller nand interface with
> HW ECC support. This controller is used in xilinx zynq soc for interfacing
> the nand flash memory.
> 
> Signed-off-by: Punnaiah Choudary Kalluri <punnaia at xilinx.com>
> Changes in v7:
>  - Currently not implemented the memclk rate adjustments. I will
>    look into this later and once the basic driver is accepted.
>  - Fixed GPL licence ident
> Changes in v6:
>  - Fixed the checkpatch.pl reported warnings
>  - Using the address cycles information from the onfi param page
>    earlier it is hardcoded to 5 in driver
> Changes in v5:
>  - Configure the nand timing parameters as per the onfi spec
> Changes in v4:
>  - Updated the driver to sync with pl353_smc driver APIs
> Changes in v3:
>  - implemented the proper error codes
>  - further breakdown this patch to multiple sets
>  - added the controller and driver details to Documentation section
>  - updated the licenece to GPLv2
>  - reorganized the pl353_nand_ecc_init function
> Changes in v2:
>  - use "depends on" rather than "select" option in kconfig
>  - remove unused variable parts
>  - remove dummy helper and use writel_relaxed directly

What is the status of getting this driver merged? I am interested in
this driver and can provide some help if there are still TODO items.

At the very least I will test it, is there something newer than v7 out
there?

Regards,
Jason



More information about the linux-mtd mailing list