[PATCH 10/10] net: mdio-sam: Add device tree documentation for SAM MDIO

[Florian Fainelli]

On 10/07/2016 08:18 AM, Pantelis Antoniou wrote:
> From: Georgi Vlaev <gvlaev at juniper.net>
> 
> Add device tree bindings document for the SAM MDIO block
> present in Juniper's SAM FPGA.
> 
> Signed-off-by: Georgi Vlaev <gvlaev at juniper.net>
> [Ported from Juniper kernel]
> Signed-off-by: Pantelis Antoniou <pantelis.antoniou at konsulko.com>
> ---
>  Documentation/devicetree/bindings/net/mdio-sam.txt | 48 ++++++++++++++++++++++
>  1 file changed, 48 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/net/mdio-sam.txt
> 
> diff --git a/Documentation/devicetree/bindings/net/mdio-sam.txt b/Documentation/devicetree/bindings/net/mdio-sam.txt
> new file mode 100644
> index 0000000..7d354e0
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/mdio-sam.txt
> @@ -0,0 +1,48 @@
> +Juniper SAM FPGA MFD MDIO bus properties.
> +
> +Required properties:
> +- compatible : "jnx,mdio-sam"
> +- reg : The start offset of the MDIO bus range
> +- #address-cells = <1>;
> +- #size-cells = <0>;
> +
> +Optional properties:
> +
> +Required properties for child nodes:
> +- #address-cells = <1>;
> +- #size-cells = <0>;
> +- reg : The MDIO bus offset within the MDIO range.

I would just refer to Documentation/devicetree/bindings/net/phy.txt for
the child node properties.

Other than that:

Reviewed-by: Florian Fainelli <f.fainelli at gmail.com>
-- 
Florian