[PATCH 08/10] gpio: ptxpmb-cpld: Document bindings of PTXPMB's CPLD GPIO

[Pantelis Antoniou]

From: Georgi Vlaev <gvlaev at juniper.net>

Add device tree bindings document for the GPIO driver of
Juniper's PTXPMB/NGPMB CPLD.

Signed-off-by: Georgi Vlaev <gvlaev at juniper.net>
[Ported from Juniper kernel]
Signed-off-by: Pantelis Antoniou <pantelis.antoniou at konsulko.com>
---
 .../bindings/gpio/jnx,gpio-ptxpmb-cpld.txt         | 30 ++++++++++++++++++++++
 1 file changed, 30 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt

diff --git a/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt
new file mode 100644
index 0000000..1122021
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt
@@ -0,0 +1,30 @@
+Juniper PTXPMB CPLD GPIO block
+
+Required properties:
+
+- compatible:
+    Must be "jnx,gpio-ptxpmb-cpld"
+
+- #gpio-cells:
+    Should be <2>.  The first cell is the pin number (within the controller's
+    pin space), and the second is used for the following flags:
+	bit[0]: direction (0 = out, 1 = in)
+	bit[1]: init high
+	bit[2]: active low
+
+- gpio-controller:
+    Specifies that the node is a GPIO controller.
+
+Optional properties:
+
+- reg:
+    Address and length of the register set for the device. Usually supplied by
+    the parent MFD driver
+
+Example:
+
+gpio_cpld: cpld_gpio {
+	compatible = "jnx,gpio-ptxpmb-cpld";
+	#gpio-cells = <2>;
+	gpio-controller;
+};
-- 
1.9.1