[PATCH 11/11] mtd: nand: denali: remove debug lines of __FILE__, __LINE__, __func__

[Marek Vasut]

On 11/09/2016 05:35 AM, Masahiro Yamada wrote:
> Such debug lines might be useful when debugging the driver first,
> but should be deleted from the upstream code.
> 
> Signed-off-by: Masahiro Yamada <yamada.masahiro at socionext.com>

Reviewed-by: Marek Vasut <marek.vasut at gmail.com>

> ---
> 
>  drivers/mtd/nand/denali.c | 12 ------------
>  1 file changed, 12 deletions(-)
> 
> diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
> index 14e66ab..e32e13c 100644
> --- a/drivers/mtd/nand/denali.c
> +++ b/drivers/mtd/nand/denali.c
> @@ -181,9 +181,6 @@ static uint16_t denali_nand_reset(struct denali_nand_info *denali)
>  {
>  	int i;
>  
> -	dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> -		__FILE__, __LINE__, __func__);
> -
>  	for (i = 0; i < denali->max_banks; i++)
>  		iowrite32(INTR_STATUS__RST_COMP | INTR_STATUS__TIME_OUT,
>  		denali->flash_reg + INTR_STATUS(i));
> @@ -233,9 +230,6 @@ static void nand_onfi_timing_set(struct denali_nand_info *denali,
>  	uint16_t acc_clks;
>  	uint16_t addr_2_data, re_2_we, re_2_re, we_2_re, cs_cnt;
>  
> -	dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> -		__FILE__, __LINE__, __func__);
> -
>  	en_lo = CEIL_DIV(Trp[mode], CLK_X);
>  	en_hi = CEIL_DIV(Treh[mode], CLK_X);
>  #if ONFI_BLOOM_TIME
> @@ -480,9 +474,6 @@ static uint16_t denali_nand_timing_set(struct denali_nand_info *denali)
>  	uint8_t maf_id, device_id;
>  	int i;
>  
> -	dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> -			__FILE__, __LINE__, __func__);
> -
>  	/*
>  	 * Use read id method to get device ID and other params.
>  	 * For some NAND chips, controller can't report the correct
> @@ -537,9 +528,6 @@ static uint16_t denali_nand_timing_set(struct denali_nand_info *denali)
>  static void denali_set_intr_modes(struct denali_nand_info *denali,
>  					uint16_t INT_ENABLE)
>  {
> -	dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> -		__FILE__, __LINE__, __func__);
> -
>  	if (INT_ENABLE)
>  		iowrite32(1, denali->flash_reg + GLOBAL_INT_ENABLE);
>  	else
> 


-- 
Best regards,
Marek Vasut