[PATCH v7 08/10] mtd: spi-nor: simplify write loop
Brian Norris
computersforpeace at gmail.com
Thu May 5 17:31:54 PDT 2016
From: Michal Suchanek <hramrach at gmail.com>
The spi-nor write loop assumes that what is passed to the hardware
driver write() is what gets written.
When write() writes less than page size at once data is dropped on the
floor. Check the amount of data writen and exit if it does not match
requested amount.
Signed-off-by: Michal Suchanek <hramrach at gmail.com>
Signed-off-by: Brian Norris <computersforpeace at gmail.com>
---
v6 -> v7:
* fix the page_offset calculation, as suggested by Han
drivers/mtd/spi-nor/spi-nor.c | 58 +++++++++++++++++++------------------------
1 file changed, 25 insertions(+), 33 deletions(-)
diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
index 937e8d6a28bb..ff96e1b54384 100644
--- a/drivers/mtd/spi-nor/spi-nor.c
+++ b/drivers/mtd/spi-nor/spi-nor.c
@@ -1128,8 +1128,8 @@ static int spi_nor_write(struct mtd_info *mtd, loff_t to, size_t len,
size_t *retlen, const u_char *buf)
{
struct spi_nor *nor = mtd_to_spi_nor(mtd);
- u32 page_offset, page_size, i;
- int ret;
+ size_t page_offset, page_remain, i;
+ ssize_t ret;
dev_dbg(nor->dev, "to 0x%08x, len %zd\n", (u32)to, len);
@@ -1137,45 +1137,37 @@ static int spi_nor_write(struct mtd_info *mtd, loff_t to, size_t len,
if (ret)
return ret;
- write_enable(nor);
-
- page_offset = to & (nor->page_size - 1);
+ for (i = 0; i < len; ) {
+ ssize_t written;
- /* do all the bytes fit onto one page? */
- if (page_offset + len <= nor->page_size) {
- ret = nor->write(nor, to, len, buf);
- if (ret < 0)
- goto write_err;
- *retlen += ret;
- } else {
+ page_offset = (to + i) & (nor->page_size - 1);
+ WARN_ONCE(page_offset,
+ "Writing at offset %zu into a NOR page. Writing partial pages may decrease reliability and increase wear of NOR flash.",
+ page_offset);
/* the size of data remaining on the first page */
- page_size = nor->page_size - page_offset;
- ret = nor->write(nor, to, page_size, buf);
+ page_remain = min_t(size_t,
+ nor->page_size - page_offset, len - i);
+
+ write_enable(nor);
+ ret = nor->write(nor, to + i, page_remain, buf + i);
if (ret < 0)
goto write_err;
- *retlen += ret;
-
- /* write everything in nor->page_size chunks */
- for (i = ret; i < len; ) {
- page_size = len - i;
- if (page_size > nor->page_size)
- page_size = nor->page_size;
-
- ret = spi_nor_wait_till_ready(nor);
- if (ret)
- goto write_err;
+ written = ret;
- write_enable(nor);
-
- ret = nor->write(nor, to + i, page_size, buf + i);
- if (ret < 0)
- goto write_err;
- *retlen += ret;
- i += ret;
+ ret = spi_nor_wait_till_ready(nor);
+ if (ret)
+ goto write_err;
+ *retlen += written;
+ i += written;
+ if (written != page_remain) {
+ dev_err(nor->dev,
+ "While writing %zu bytes written %zd bytes\n",
+ page_remain, written);
+ ret = -EIO;
+ goto write_err;
}
}
- ret = spi_nor_wait_till_ready(nor);
write_err:
spi_nor_unlock_and_unprep(nor, SPI_NOR_OPS_WRITE);
return ret;
--
2.8.0.rc3.226.g39d4020
More information about the linux-mtd
mailing list