[PATCH] mtd: nandsim: Relax page size restrictions
Richard Weinberger
richard at nod.at
Mon May 2 13:31:03 PDT 2016
Allow any page size as long it is a power of two and less
than KMALLOC_MAX_SIZE.
Signed-off-by: Richard Weinberger <richard at nod.at>
---
drivers/mtd/nand/nandsim.c | 26 +++++++++++++-------------
1 file changed, 13 insertions(+), 13 deletions(-)
diff --git a/drivers/mtd/nand/nandsim.c b/drivers/mtd/nand/nandsim.c
index 66e87c6..9a444e2 100644
--- a/drivers/mtd/nand/nandsim.c
+++ b/drivers/mtd/nand/nandsim.c
@@ -175,9 +175,6 @@ MODULE_PARM_DESC(bbt, "0 OOB, 1 BBT with marker in OOB, 2 BBT with marker in d
MODULE_PARM_DESC(bch, "Enable BCH ecc and set how many bits should "
"be correctable in 512-byte blocks");
-/* The largest possible page size */
-#define NS_LARGEST_PAGE_SIZE 4096
-
/* The prefix for simulator output */
#define NS_OUTPUT_PREFIX "[nandsim]"
@@ -267,10 +264,8 @@ MODULE_PARM_DESC(bch, "Enable BCH ecc and set how many bits should "
#define OPT_ANY 0xFFFFFFFF /* any chip supports this operation */
#define OPT_PAGE512 0x00000002 /* 512-byte page chips */
-#define OPT_PAGE2048 0x00000008 /* 2048-byte page chips */
+#define OPT_LARGEPAGE 0x00000008 /* >= 2048-byte page chips */
#define OPT_PAGE512_8BIT 0x00000040 /* 512-byte page chips with 8-bit bus width */
-#define OPT_PAGE4096 0x00000080 /* 4096-byte page chips */
-#define OPT_LARGEPAGE (OPT_PAGE2048 | OPT_PAGE4096) /* 2048 & 4096-byte page chips */
#define OPT_SMALLPAGE (OPT_PAGE512) /* 512-byte page chips */
/* Remove action bits from state */
@@ -699,13 +694,18 @@ static int init_nandsim(struct mtd_info *mtd)
ns->options |= OPT_PAGE512;
if (ns->busw == 8)
ns->options |= OPT_PAGE512_8BIT;
- } else if (ns->geom.pgsz == 2048) {
- ns->options |= OPT_PAGE2048;
- } else if (ns->geom.pgsz == 4096) {
- ns->options |= OPT_PAGE4096;
- } else {
- NS_ERR("init_nandsim: unknown page size %u\n", ns->geom.pgsz);
- return -EIO;
+ } else if (ns->geom.pgsz >= 2048) {
+ ns->options |= OPT_LARGEPAGE;
+ }
+
+ if (!is_power_of_2(ns->geom.pgsz)) {
+ NS_ERR("page size is not a power of two.\n");
+ return -EINVAL;
+ }
+
+ if (ns->geom.pgszoob > KMALLOC_MAX_SIZE) {
+ NS_ERR("page size plus oob too large: %u.\n", ns->geom.pgszoob);
+ return -EINVAL;
}
if (ns->options & OPT_SMALLPAGE) {
--
2.7.3
More information about the linux-mtd
mailing list