[PATCH v2 2/2] doc: dt: mtd: add a DT property to enable the use of 4byte-address op codes

[Cyrille Pitchen]

Hi all,

Since the framework is named spi-nor, what about spi-nor-4byte-opcodes?
Is it okay for everyone?

It would follow the same pattern as spi-max-frequency which applies to all SPI
devices.

Best regards,

Cyrille

Le 23/03/2016 16:08, Cyrille Pitchen a écrit :
> Hi Rob,
> 
> sorry I've sent v3 at the same time as you answered to v2.
> I'll take your comments into account for v4.
> 
> Brian, any preference between 4byte-opcodes or m25p-4byte-opcodes?
> 
> Best regards,
> 
> Cyrille
> 
> Le 23/03/2016 13:49, Rob Herring a écrit :
>> On Tue, Mar 22, 2016 at 10:13 AM, Cyrille Pitchen
>> <cyrille.pitchen at atmel.com> wrote:
>>> This patch adds a new optional DT property which enables an alternative
>>> way of supporting memory size above 16MiB (128Mib). This new mechanism
>>> translates the regular 3byte-address op codes into their 4byte-address
>>> version whereas the old/default mecanism makes the SPI memory enter its
>>> 4byte-address mode, which has annoying side effects for early bootloaders.
>>>
>>> We cannot discover at run time whether the SPI NOR memory supports the
>>> 4byte-address op codes. For instance both Macronix MX25L25635E and
>>> MX25L25673G share the same JEDEC ID (C22019 without any extension byte).
>>> However the first one doesn't support 4byte-address op codes whereas the
>>> second one does.
>>>
>>> Signed-off-by: Cyrille Pitchen <cyrille.pitchen at atmel.com>
>>> ---
>>>  Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt | 11 +++++++++++
>>>  1 file changed, 11 insertions(+)
>>>
>>> diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
>>> index 2c91c03e7eb0..8be610482089 100644
>>> --- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
>>> +++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
>>> @@ -66,6 +66,17 @@ Optional properties:
>>>                     Refer to your chips' datasheet to check if this is supported
>>>                     by your chip.
>>>
>>> +- m25p,4byte-opcodes: For memory size above 16MiB (128Mib), use the dedicated
>>
>> m25p is not a vendor. So drop it or m25p-4byte-opcodes.
>>
>>> +                      4byte-address opcodes instead of entering the 4byte
>>> +                      address mode. This mode changes the internal state of the
>>> +                      chip so may conflict with some early boot loaders, which
>>> +                      expect to use the regular (Fast) Read opcodes with 3byte
>>> +                      address.
>>> +                      However 4byte-address opcodes are not supported by all
>>> +                      chips and support for them can not be detected at runtime.
>>
>> s/can not/cannot/
>>
>>> +                      Refer to you chip's datasheet to check if this is
>>> +                      supported by your chip.
>>> +
>>>  Example:
>>>
>>>         flash: m25p80 at 0 {
>>> --
>>> 1.8.2.2
>>>
>