[PATCH] mtd: nand: Fix nand_command_lp() for 8bits opcodes

Boris Brezillon boris.brezillon at free-electrons.com
Wed Jun 15 04:09:51 PDT 2016


8 bits opcodes should be followed by a single address cycle. Make the
2nd address cycle dependent of !nand_opcode_8bits(command).

Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
---
 drivers/mtd/nand/nand_base.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
index 0b0dc29..c2f83236 100644
--- a/drivers/mtd/nand/nand_base.c
+++ b/drivers/mtd/nand/nand_base.c
@@ -745,7 +745,10 @@ static void nand_command_lp(struct mtd_info *mtd, unsigned int command,
 				column >>= 1;
 			chip->cmd_ctrl(mtd, column, ctrl);
 			ctrl &= ~NAND_CTRL_CHANGE;
-			chip->cmd_ctrl(mtd, column >> 8, ctrl);
+
+			/* Only ouput a single addr cycle for 8bits opcodes. */
+			if (!nand_opcode_8bits(command))
+				chip->cmd_ctrl(mtd, column >> 8, ctrl);
 		}
 		if (page_addr != -1) {
 			chip->cmd_ctrl(mtd, page_addr, ctrl);
-- 
2.7.4




More information about the linux-mtd mailing list