[PATCH] mtd: nand: brcmnand: Change BUG_ON in brcmnand_send_cmd

[Kamal Dasu]

On Sat, Jul 9, 2016 at 9:30 PM, Brian Norris
<computersforpeace at gmail.com> wrote:
> On Fri, Jul 08, 2016 at 10:36:39AM -0700, Florian Fainelli wrote:
>> Change the BUG_ON() condition in brcmnand_send_cmd() which checks for
>> the interrupt status "controller ready" bit to a WARN_ON.
>>
>> There is no good reason to kill the system when this condition occur
>> because we could have systems which listed the NAND controller as
>> available (e.g: from Device Tree), but the NAND chip could be
>> malfunctioning and not responding.
>>
>> Signed-off-by: Florian Fainelli <f.fainelli at gmail.com>
>
> Acked-by: Brian Norris <computersforpeace at gmail.com>
>

Reviewed-by: Kamal Dasu <kdasu.kdev at gmail.com>

>> ---
>> Note that I even hesitated to remove that completely, but there is
>> some value in knowing about this condition since it helps figuring
>> out what could be wrong.
>>
>>  drivers/mtd/nand/brcmnand/brcmnand.c | 2 +-
>>  1 file changed, 1 insertion(+), 1 deletion(-)
>>
>> diff --git a/drivers/mtd/nand/brcmnand/brcmnand.c b/drivers/mtd/nand/brcmnand/brcmnand.c
>> index b6062a2f3dfd..72bdc283778d 100644
>> --- a/drivers/mtd/nand/brcmnand/brcmnand.c
>> +++ b/drivers/mtd/nand/brcmnand/brcmnand.c
>> @@ -1165,7 +1165,7 @@ static void brcmnand_send_cmd(struct brcmnand_host *host, int cmd)
>>       ctrl->cmd_pending = cmd;
>>
>>       intfc = brcmnand_read_reg(ctrl, BRCMNAND_INTFC_STATUS);
>> -     BUG_ON(!(intfc & INTFC_CTLR_READY));
>> +     WARN_ON(!(intfc & INTFC_CTLR_READY));
>>
>>       mb(); /* flush previous writes */
>>       brcmnand_write_reg(ctrl, BRCMNAND_CMD_START,
>> --
>> 2.7.4
>>



-- 
Kamal Dasu
Principal Engineer | Broadcom Ltd. 200 Brickstone Sq Andover | 978-719-1405