[PATCH 02/12] mtd: nand: atmel: rely on generic DT parsing done in nand_scan_ident()
Boris Brezillon
boris.brezillon at free-electrons.com
Fri Apr 1 05:54:22 PDT 2016
The core now takes care of parsing generic DT properties in
nand_scan_ident() when nand_set_flash_node() has been called.
Rely on this initialization instead of calling of_get_nand_xxx()
manually.
Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
---
drivers/mtd/nand/atmel_nand.c | 133 +++++++++++++++++++++++-------------------
1 file changed, 73 insertions(+), 60 deletions(-)
diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 0b5da72..5e716f2 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -36,7 +36,6 @@
#include <linux/of.h>
#include <linux/of_device.h>
#include <linux/of_gpio.h>
-#include <linux/of_mtd.h>
#include <linux/mtd/mtd.h>
#include <linux/mtd/nand.h>
#include <linux/mtd/partitions.h>
@@ -434,14 +433,13 @@ err_buf:
static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
{
struct nand_chip *chip = mtd_to_nand(mtd);
- struct atmel_nand_host *host = nand_get_controller_data(chip);
if (use_dma && len > mtd->oobsize)
/* only use DMA for bigger than oob size: better performances */
if (atmel_nand_dma_op(mtd, buf, len, 1) == 0)
return;
- if (host->board.bus_width_16)
+ if (chip->options & NAND_BUSWIDTH_16)
atmel_read_buf16(mtd, buf, len);
else
atmel_read_buf8(mtd, buf, len);
@@ -450,14 +448,13 @@ static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
static void atmel_write_buf(struct mtd_info *mtd, const u8 *buf, int len)
{
struct nand_chip *chip = mtd_to_nand(mtd);
- struct atmel_nand_host *host = nand_get_controller_data(chip);
if (use_dma && len > mtd->oobsize)
/* only use DMA for bigger than oob size: better performances */
if (atmel_nand_dma_op(mtd, (void *)buf, len, 0) == 0)
return;
- if (host->board.bus_width_16)
+ if (chip->options & NAND_BUSWIDTH_16)
atmel_write_buf16(mtd, buf, len);
else
atmel_write_buf8(mtd, buf, len);
@@ -1507,58 +1504,17 @@ static void atmel_nand_hwctl(struct mtd_info *mtd, int mode)
ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
}
-static int atmel_of_init_port(struct atmel_nand_host *host,
- struct device_node *np)
+static int atmel_of_init_ecc(struct atmel_nand_host *host,
+ struct device_node *np)
{
- u32 val;
u32 offset[2];
- int ecc_mode;
- struct atmel_nand_data *board = &host->board;
- enum of_gpio_flags flags = 0;
-
- host->caps = (struct atmel_nand_caps *)
- of_device_get_match_data(host->dev);
-
- if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
- if (val >= 32) {
- dev_err(host->dev, "invalid addr-offset %u\n", val);
- return -EINVAL;
- }
- board->ale = val;
- }
-
- if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
- if (val >= 32) {
- dev_err(host->dev, "invalid cmd-offset %u\n", val);
- return -EINVAL;
- }
- board->cle = val;
- }
-
- ecc_mode = of_get_nand_ecc_mode(np);
-
- board->ecc_mode = ecc_mode < 0 ? NAND_ECC_SOFT : ecc_mode;
-
- board->on_flash_bbt = of_get_nand_on_flash_bbt(np);
-
- board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
-
- if (of_get_nand_bus_width(np) == 16)
- board->bus_width_16 = 1;
-
- board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
- board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
-
- board->enable_pin = of_get_gpio(np, 1);
- board->det_pin = of_get_gpio(np, 2);
+ u32 val;
host->has_pmecc = of_property_read_bool(np, "atmel,has-pmecc");
- /* load the nfc driver if there is */
- of_platform_populate(np, NULL, NULL, host->dev);
-
- if (!(board->ecc_mode == NAND_ECC_HW) || !host->has_pmecc)
- return 0; /* Not using PMECC */
+ /* Not using PMECC */
+ if (!(host->nand_chip.ecc.mode == NAND_ECC_HW) || !host->has_pmecc)
+ return 0;
/* use PMECC, get correction capability, sector size and lookup
* table offset.
@@ -1599,16 +1555,64 @@ static int atmel_of_init_port(struct atmel_nand_host *host,
/* Will build a lookup table and initialize the offset later */
return 0;
}
+
if (!offset[0] && !offset[1]) {
dev_err(host->dev, "Invalid PMECC lookup table offset\n");
return -EINVAL;
}
+
host->pmecc_lookup_table_offset_512 = offset[0];
host->pmecc_lookup_table_offset_1024 = offset[1];
return 0;
}
+static int atmel_of_init_port(struct atmel_nand_host *host,
+ struct device_node *np)
+{
+ u32 val;
+ struct atmel_nand_data *board = &host->board;
+ enum of_gpio_flags flags = 0;
+
+ host->caps = (struct atmel_nand_caps *)
+ of_device_get_match_data(host->dev);
+
+ if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
+ if (val >= 32) {
+ dev_err(host->dev, "invalid addr-offset %u\n", val);
+ return -EINVAL;
+ }
+ board->ale = val;
+ }
+
+ if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
+ if (val >= 32) {
+ dev_err(host->dev, "invalid cmd-offset %u\n", val);
+ return -EINVAL;
+ }
+ board->cle = val;
+ }
+
+ board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
+
+ board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
+ board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
+
+ board->enable_pin = of_get_gpio(np, 1);
+ board->det_pin = of_get_gpio(np, 2);
+
+ /* load the nfc driver if there is */
+ of_platform_populate(np, NULL, NULL, host->dev);
+
+ /*
+ * Initialize ECC mode to NAND_ECC_SOFT so that we have a correct value
+ * even if the nand-ecc-mode property is not defined.
+ */
+ host->nand_chip.ecc.mode = NAND_ECC_SOFT;
+
+ return 0;
+}
+
static int atmel_hw_nand_init_params(struct platform_device *pdev,
struct atmel_nand_host *host)
{
@@ -2150,6 +2154,11 @@ static int atmel_nand_probe(struct platform_device *pdev)
} else {
memcpy(&host->board, dev_get_platdata(&pdev->dev),
sizeof(struct atmel_nand_data));
+ nand_chip->ecc.mode = host->board.ecc_mode;
+
+ /* 16-bit bus width */
+ if (host->board.bus_width_16)
+ nand_chip->options |= NAND_BUSWIDTH_16;
}
/* link the private data structures */
@@ -2191,11 +2200,8 @@ static int atmel_nand_probe(struct platform_device *pdev)
nand_chip->cmd_ctrl = atmel_nand_cmd_ctrl;
}
- nand_chip->ecc.mode = host->board.ecc_mode;
nand_chip->chip_delay = 40; /* 40us command delay time */
- if (host->board.bus_width_16) /* 16-bit bus width */
- nand_chip->options |= NAND_BUSWIDTH_16;
nand_chip->read_buf = atmel_read_buf;
nand_chip->write_buf = atmel_write_buf;
@@ -2228,11 +2234,6 @@ static int atmel_nand_probe(struct platform_device *pdev)
}
}
- if (host->board.on_flash_bbt || on_flash_bbt) {
- dev_info(&pdev->dev, "Use On Flash BBT\n");
- nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
- }
-
if (!host->board.has_dma)
use_dma = 0;
@@ -2259,6 +2260,18 @@ static int atmel_nand_probe(struct platform_device *pdev)
goto err_scan_ident;
}
+ if (host->board.on_flash_bbt || on_flash_bbt)
+ nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
+
+ if (nand_chip->bbt_options & NAND_BBT_USE_FLASH)
+ dev_info(&pdev->dev, "Use On Flash BBT\n");
+
+ if (IS_ENABLED(CONFIG_OF) && pdev->dev.of_node) {
+ res = atmel_of_init_ecc(host, pdev->dev.of_node);
+ if (res)
+ goto err_hw_ecc;
+ }
+
if (nand_chip->ecc.mode == NAND_ECC_HW) {
if (host->has_pmecc)
res = atmel_pmecc_nand_init_params(pdev, host);
--
2.5.0
More information about the linux-mtd
mailing list