[PATCH] mtd: nand: Fix Spansion sparearea size detection

[Brian Norris]

On Mon, Nov 30, 2015 at 07:19:22PM -0500, Nikolay Martynov wrote:
> Hi.
> 
>   I'm using mt7621 board, so this would be mtk_nand with matches from openwrt.

Sorry, you'll have to address this to the OpenWrt team then. I see the
OpenWrt NAND driver for your board is pretty crappy, but it might be
fixable to support ONFI properly.

Cc'ing John, who checked in mtk_nand.c into OpenWrt, I think.

Regards,
Brian

> 2015-11-30 19:09 GMT-05:00 Brian Norris <computersforpeace at gmail.com>:
> > Hi Nikolay,
> >
> > On Mon, Nov 30, 2015 at 06:59:32PM -0500, Nikolay Martynov wrote:
> >>   I'm sorry, I only have board with S34ML02G2 and I've tested by
> >> change on it - it works fine. But unfortunately I do not have any way
> >> to test S34ML01G2.
> >>   It looks like that logic can be simplified if just check id_data[1]
> >> is one of 0xda, 0xdc, 0xca, 0xcc - this should be safer option.
> >
> > Possibly safer, but it's uglier, and I'd like not to have to make this
> > change at all, if ONFI can help it.
> >
> >>   I'm sorry, I'm very new to all this. This patch made kernel boot on
> >> a board that I have. The kernel was 'oldish' - 3.18. So I'm not sure
> >> why ONFI is not used here, I will see if I can figure it out.
> >
> > What NAND driver are you using? It's possible that it doesn't support
> > the PARAMETER READ command properly. If so, it'd be better to fix that
> > than to clutter the NAND core.
> >
> > Regards,
> > Brian
> 
> 
> 
> -- 
> Martynov Nikolay.
> Email: mar.kolya at gmail.com