[PATCH] mtd: fsmc_nand.c: Use default timings if none are provided in the dts

[Stefan Roese]

Without this patch the timings are all set to 0 if not specified in the dts.
With this patch the driver falls back to use the defaults that are already
present in the driver and are known to work okay for some (older) boards.

Tested on a custom SPEAr600 based board.

Signed-off-by: Stefan Roese <sr at denx.de>
Cc: Viresh Kumar <viresh.linux at gmail.com>
Cc: Brian Norris <computersforpeace at gmail.com>
Cc: Linus Walleij <linus.walleij at linaro.org>
Cc: Mian Yousaf Kaukab <mian.yousaf.kaukab at stericsson.com>
---
 drivers/mtd/nand/fsmc_nand.c | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/fsmc_nand.c b/drivers/mtd/nand/fsmc_nand.c
index edfaa21..e58af4b 100644
--- a/drivers/mtd/nand/fsmc_nand.c
+++ b/drivers/mtd/nand/fsmc_nand.c
@@ -873,6 +873,7 @@ static int fsmc_nand_probe_config_dt(struct platform_device *pdev,
 {
 	struct fsmc_nand_platform_data *pdata = dev_get_platdata(&pdev->dev);
 	u32 val;
+	int ret;
 
 	/* Set default NAND width to 8 bits */
 	pdata->width = 8;
@@ -891,8 +892,12 @@ static int fsmc_nand_probe_config_dt(struct platform_device *pdev,
 				sizeof(*pdata->nand_timings), GFP_KERNEL);
 	if (!pdata->nand_timings)
 		return -ENOMEM;
-	of_property_read_u8_array(np, "timings", (u8 *)pdata->nand_timings,
+	ret = of_property_read_u8_array(np, "timings", (u8 *)pdata->nand_timings,
 						sizeof(*pdata->nand_timings));
+	if (ret) {
+		dev_info(&pdev->dev, "No timings in dts specified, using default timings!\n");
+		pdata->nand_timings = NULL;
+	}
 
 	/* Set default NAND bank to 0 */
 	pdata->bank = 0;
-- 
2.3.3