[PATCH v4 2/2] ARM: mvebu: a385-db-ap: Enable the NAND

[Gregory CLEMENT]

Hi Maxime,

On 18/02/2015 11:32, Maxime Ripard wrote:
> The Armada 385 Access Point Development Board has a 1GB NAND SLC chip from
> Micron as its main storage. Enable it.

I wanted applying your patch but it failed. Actually it depends on your
other patch "ARM: mvebu: armada-385-ap: Enable USB3 port" and this patch
depend on an other patch "usb: xhci: plat: Add USB phy support" which
hadn't been merged.

So either you send a new version which apply on 4.0-rc1, or we can wait for
that "usb: xhci: plat: Add USB phy support" will be merged then I will be able
applying "ARM: mvebu: armada-385-ap: Enable USB3 port" and finally this patch.
As you want.


Thanks,

Gregory


> 
> Signed-off-by: Maxime Ripard <maxime.ripard at free-electrons.com>
> ---
>  arch/arm/boot/dts/armada-385-db-ap.dts | 13 +++++++++++++
>  1 file changed, 13 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/armada-385-db-ap.dts b/arch/arm/boot/dts/armada-385-db-ap.dts
> index b891b4c897f5..ee648fb19075 100644
> --- a/arch/arm/boot/dts/armada-385-db-ap.dts
> +++ b/arch/arm/boot/dts/armada-385-db-ap.dts
> @@ -130,6 +130,19 @@
>  				phy-mode = "rgmii-id";
>  			};
>  
> +			nfc: flash at d0000 {
> +				status = "okay";
> +				#address-cells = <1>;
> +				#size-cells = <1>;
> +
> +				num-cs = <1>;
> +				nand-ecc-strength = <4>;
> +				nand-ecc-step-size = <512>;
> +				marvell,nand-keep-config;
> +				marvell,nand-enable-arbiter;
> +				nand-on-flash-bbt;
> +			};
> +
>  			usb3 at f0000 {
>  				status = "okay";
>  				usb-phy = <&usb3_phy>;
> 


-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com