[PATCH V6 1/2] mtd: spi-nor: Bindings for Cadence Quad SPI Flash Controller driver.
Graham Moore
grmoore at opensource.altera.com
Tue Jul 28 10:38:02 PDT 2015
Signed-off-by: Graham Moore <grmoore at opensource.altera.com>
---
V2: Add cdns prefix to driver-specific bindings.
V3: Use existing property "is-decoded-cs" instead of creating a duplicate,
"ext-decoder". Timing parameters are in nanoseconds, not master reference
clocks. Remove bus-num completely.
V4: Add new properties fifo-width and trigger-address
---
.../devicetree/bindings/mtd/cadence_quadspi.txt | 54 ++++++++++++++++++++
1 file changed, 54 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mtd/cadence_quadspi.txt
diff --git a/Documentation/devicetree/bindings/mtd/cadence_quadspi.txt b/Documentation/devicetree/bindings/mtd/cadence_quadspi.txt
new file mode 100644
index 0000000..d7e6fdd
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/cadence_quadspi.txt
@@ -0,0 +1,54 @@
+* Cadence Quad SPI controller
+
+Required properties:
+- compatible : Should be "cdns,qspi-nor".
+- reg : Contains two entries, each of which is a tuple consisting of a
+ physical address and length. The first entry is the address and
+ length of the controller register set. The second entry is the
+ address and length of the QSPI Controller data area.
+- interrupts : Unit interrupt specifier for the controller interrupt.
+- clocks : phandle to the Quad SPI clock.
+- fifo-depth : Size of the data FIFO in words.
+- fifo-width: Bus width of the data FIFO in bytes.
+- trigger-address : 32-bit indirect AHB trigger address.
+
+Optional properties:
+- is-decoded-cs : Flag to indicate whether decoder is used or not.
+
+Optional subnodes:
+Subnodes of the Cadence Quad SPI controller are spi slave nodes with additional
+custom properties:
+- cdns,page-size : Size, in bytes, of the device's write page
+- cdns,block-size : Size of the device's erase block
+- cdns,read-delay : Delay for read capture logic, in clock cycles
+- cdns,tshsl-ns : Delay in nanoseconds for the length that the master mode chip select outputs are de-asserted between transactions.
+- cdns,tsd2d-ns : Delay in nanoseconds between one chip select being de-activated and the activation of another.
+- cdns,tchsh-ns : Delay in nanoseconds between last bit of current transaction and deasserting the device chip select (qspi_n_ss_out).
+- cdns,tslch-ns : Delay in nanoseconds between setting qspi_n_ss_out low and first bit transfer.
+
+Example:
+
+ qspi: spi at ff705000 {
+ compatible = "cdns,qspi-nor";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0xff705000 0x1000>,
+ <0xffa00000 0x1000>;
+ interrupts = <0 151 4>;
+ clocks = <&qspi_clk>;
+ is-decoded-cs = <1>;
+ fifo-depth = <128>;
+ fifo-width = <4>;
+ trigger-address = <0x00000000>;
+
+ flash0: n25q00 at 0 {
+ ...
+ cdns,page-size = <256>;
+ cdns,block-size = <16>;
+ cdns,read-delay = <4>;
+ cdns,tshsl-ns = <50>;
+ cdns,tsd2d-ns = <50>;
+ cdns,tchsh-ns = <4>;
+ cdns,tslch-ns = <4>;
+ }
+ }
--
1.7.9.5
More information about the linux-mtd
mailing list