[PATCH v2 2/4] mtd: pxa3xx_nand: add helpers to setup the timings

[Ezequiel Garcia]

On 07/07/2015 12:08 PM, Antoine Tenart wrote:
> Add helpers to setup the timings in the pxa3xx driver. These helpers
> allow to either make use of the nand framework nand_sdr_timings or the
> pxa3xx specific pxa3xx_nand_host, for compatibility reasons.
>
> Signed-off-by: Antoine Tenart <antoine.tenart at free-electrons.com>
> ---
>   drivers/mtd/nand/pxa3xx_nand.c | 91 ++++++++++++++++++++++++++++++++++++++++++
>   1 file changed, 91 insertions(+)
>
> diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c
> index 5465fa439c9e..9a95c24ab2ce 100644
> --- a/drivers/mtd/nand/pxa3xx_nand.c
> +++ b/drivers/mtd/nand/pxa3xx_nand.c
> @@ -385,6 +385,97 @@ static void pxa3xx_nand_set_timing(struct pxa3xx_nand_host *host,
>   	nand_writel(info, NDTR1CS0, ndtr1);
>   }
>
> +static void pxa3xx_nand_set_sdr_timing(struct pxa3xx_nand_host *host,
> +				       const struct nand_sdr_timings *t)
> +{
> +	struct pxa3xx_nand_info *info = host->info_data;
> +	struct nand_chip *chip = &host->chip;
> +	unsigned long nand_clk = clk_get_rate(info->clk);
> +	uint32_t ndtr0, ndtr1;
> +
> +	u32 tCH_min = DIV_ROUND_UP(t->tCH_min, 1000);
> +	u32 tCS_min = DIV_ROUND_UP(t->tCS_min, 1000);
> +	u32 tWH_min = DIV_ROUND_UP(t->tWH_min, 1000);
> +	u32 tWP_min = DIV_ROUND_UP(t->tWC_min - tWH_min, 1000);

Is the substraction above correct? You seem to be substracting
picoseconds to nanoseconds.

> +	u32 tREH_min = DIV_ROUND_UP(t->tREH_min, 1000);
> +	u32 tRP_min = DIV_ROUND_UP(t->tRC_min - tREH_min, 1000);

Ditto.

> +	u32 tR = chip->chip_delay * 1000;
> +	u32 tWHR_min = DIV_ROUND_UP(t->tWHR_min, 1000);
> +	u32 tAR_min = DIV_ROUND_UP(t->tAR_min, 1000);
> +
> +	/* fallback to a default value if tR = 0 */
> +	if (!tR)
> +		tR = 20000;
> +
> +	ndtr0 = NDTR0_tCH(ns2cycle(tCH_min, nand_clk)) |
> +		NDTR0_tCS(ns2cycle(tCS_min, nand_clk)) |
> +		NDTR0_tWH(ns2cycle(tWH_min, nand_clk)) |
> +		NDTR0_tWP(ns2cycle(tWP_min, nand_clk)) |
> +		NDTR0_tRH(ns2cycle(tREH_min, nand_clk)) |
> +		NDTR0_tRP(ns2cycle(tRP_min, nand_clk));
> +
> +	ndtr1 = NDTR1_tR(ns2cycle(tR, nand_clk)) |
> +		NDTR1_tWHR(ns2cycle(tWHR_min, nand_clk)) |
> +		NDTR1_tAR(ns2cycle(tAR_min, nand_clk));
> +
> +	info->ndtr0cs0 = ndtr0;
> +	info->ndtr1cs0 = ndtr1;
> +	nand_writel(info, NDTR0CS0, ndtr0);
> +	nand_writel(info, NDTR1CS0, ndtr1);
> +}
> +
> +static int pxa3xx_nand_init_timings(struct pxa3xx_nand_host *host)
> +{
> +	const struct nand_sdr_timings *timings;
> +	struct nand_chip *chip = &host->chip;
> +	struct pxa3xx_nand_info *info = host->info_data;
> +	const struct pxa3xx_nand_flash *f = NULL;
> +	int mode, id, ntypes, i;
> +
> +	mode = onfi_get_async_timing_mode(chip);
> +	if (mode == ONFI_TIMING_MODE_UNKNOWN) {
> +		ntypes = ARRAY_SIZE(builtin_flash_types);
> +
> +		chip->cmdfunc(host->mtd, NAND_CMD_READID, 0x00, -1);
> +
> +		id = chip->read_byte(host->mtd);
> +		id |= chip->read_byte(host->mtd) << 0x8;
> +
> +		for (i = 0; i < ntypes; i++) {
> +			f = &builtin_flash_types[i];
> +
> +			if (f->chip_id == id)
> +				break;
> +		}
> +
> +		if (i == ntypes) {
> +			dev_err(&info->pdev->dev, "Error: timings not found\n");
> +			return -EINVAL;
> +		}
> +
> +		pxa3xx_nand_set_timing(host, f->timing);
> +
> +		if (f->flash_width == 16) {
> +			info->reg_ndcr |= NDCR_DWIDTH_M;
> +			chip->options |= NAND_BUSWIDTH_16;
> +		}
> +
> +		info->reg_ndcr |= (f->dfc_width == 16) ? NDCR_DWIDTH_C : 0;

Nitpick: the 16-bit flash configuration doesn't belong in a function
called "xxx_init_timings".

> +	} else {
> +		mode = fls(mode) - 1;
> +		if (mode < 0)
> +			mode = 0;
> +
> +		timings = onfi_async_timing_mode_to_sdr_timings(mode);
> +		if (IS_ERR(timings))
> +			return PTR_ERR(timings);
> +
> +		pxa3xx_nand_set_sdr_timing(host, timings);
> +	}
> +
> +	return 0;
> +}
> +
>   /*
>    * Set the data and OOB size, depending on the selected
>    * spare and ECC configuration.
>

Thanks,
-- 
Ezequiel Garcia, VanguardiaSur
www.vanguardiasur.com.ar