[PATCH v8 1/7] mtd: nand: gpmi: add gpmi dsm supend/resume support

Han Xu b45815 at freescale.com
Wed Dec 2 14:47:40 PST 2015


From: Huang Shijie <b32955 at freescale.com>

i.MX6SX supports deep sleep mode(DSM) that may turn off GPMI/BCH power
during suspend, add gpmi nand suspend/resume function to release DMA
channel in suspend function and re-init GPMI/BCH controller during
resume function.

Although it is not necessary to restore GPMI/BCH registers value for
i.MX6QDL, the code doesn't distinguish different platforms to keep the
code simple.

Signed-off-by: Huang Shijie <b32955 at freescale.com>
Signed-off-by: Han Xu <han.xu at freescale.com>
---
 drivers/mtd/nand/gpmi-nand/gpmi-nand.c | 47 +++++++++++++++++++++++++++++++++-
 1 file changed, 46 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/gpmi-nand/gpmi-nand.c b/drivers/mtd/nand/gpmi-nand/gpmi-nand.c
index 5a9b696..ba5975f 100644
--- a/drivers/mtd/nand/gpmi-nand/gpmi-nand.c
+++ b/drivers/mtd/nand/gpmi-nand/gpmi-nand.c
@@ -1,7 +1,7 @@
 /*
  * Freescale GPMI NAND Flash Driver
  *
- * Copyright (C) 2010-2011 Freescale Semiconductor, Inc.
+ * Copyright (C) 2010-2015 Freescale Semiconductor, Inc.
  * Copyright (C) 2008 Embedded Alley Solutions, Inc.
  *
  * This program is free software; you can redistribute it and/or modify
@@ -2035,9 +2035,54 @@ static int gpmi_nand_remove(struct platform_device *pdev)
 	return 0;
 }
 
+#ifdef CONFIG_PM_SLEEP
+static int gpmi_pm_suspend(struct device *dev)
+{
+	struct gpmi_nand_data *this = dev_get_drvdata(dev);
+
+	release_dma_channels(this);
+	return 0;
+}
+
+static int gpmi_pm_resume(struct device *dev)
+{
+	struct gpmi_nand_data *this = dev_get_drvdata(dev);
+	int ret;
+
+	ret = acquire_dma_channels(this);
+	if (ret < 0)
+		return ret;
+
+	/* re-init the GPMI registers */
+	this->flags &= ~GPMI_TIMING_INIT_OK;
+	ret = gpmi_init(this);
+	if (ret) {
+		dev_err(this->dev, "Error setting GPMI : %d\n", ret);
+		return ret;
+	}
+
+	/* re-init the BCH registers */
+	ret = bch_set_geometry(this);
+	if (ret) {
+		dev_err(this->dev, "Error setting BCH : %d\n", ret);
+		return ret;
+	}
+
+	/* re-init others */
+	gpmi_extra_init(this);
+
+	return 0;
+}
+#endif /* CONFIG_PM_SLEEP */
+
+static const struct dev_pm_ops gpmi_pm_ops = {
+	SET_SYSTEM_SLEEP_PM_OPS(gpmi_pm_suspend, gpmi_pm_resume)
+};
+
 static struct platform_driver gpmi_nand_driver = {
 	.driver = {
 		.name = "gpmi-nand",
+		.pm = &gpmi_pm_ops,
 		.of_match_table = gpmi_nand_id_table,
 	},
 	.probe   = gpmi_nand_probe,
-- 
1.9.1




More information about the linux-mtd mailing list