[PATCH v4 09/10] mtd: spi-nor: fsl-quadspi: reset the module in the probe

[Han Xu]

From: Frank Li <Frank.Li at freescale.com>

The uboot may run the QuadSpi controler with command:
    #sf probe

So we should reset the module in the probe.
This patch also clear the pending interrupts which arised by the uboot
code.

Signed-off-by: Huang Shijie <shijie8 at gmail.com>
Signed-off-by: Frank Li <Frank.Li at freescale.com>
---
 drivers/mtd/spi-nor/fsl-quadspi.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/mtd/spi-nor/fsl-quadspi.c b/drivers/mtd/spi-nor/fsl-quadspi.c
index c8e0eb6..d09fb28 100644
--- a/drivers/mtd/spi-nor/fsl-quadspi.c
+++ b/drivers/mtd/spi-nor/fsl-quadspi.c
@@ -716,6 +716,11 @@ static int fsl_qspi_nor_setup(struct fsl_qspi *q)
 	if (ret)
 		return ret;
 
+	/* Reset the module */
+	writel(QUADSPI_MCR_SWRSTSD_MASK | QUADSPI_MCR_SWRSTHD_MASK,
+		base + QUADSPI_MCR);
+	udelay(1);
+
 	/* Init the LUT table. */
 	fsl_qspi_init_lut(q);
 
@@ -733,6 +738,9 @@ static int fsl_qspi_nor_setup(struct fsl_qspi *q)
 	writel(QUADSPI_MCR_RESERVED_MASK | QUADSPI_MCR_END_CFG_MASK,
 			base + QUADSPI_MCR);
 
+	/* clear all interrupt status */
+	writel(0xffffffff, q->iobase + QUADSPI_FR);
+
 	/* enable the interrupt */
 	writel(QUADSPI_RSER_TFIE, q->iobase + QUADSPI_RSER);
 
-- 
1.9.1