[PATCH v3 5/5] arm: qcom: dts: Enable NAND node on IPQ8064 AP148 platform

[Archit Taneja]

On 8/4/2015 2:28 AM, Stephen Boyd wrote:
> On 08/03, Archit Taneja wrote:
>> @@ -93,5 +115,19 @@
>>   		sata at 29000000 {
>>   			status = "ok";
>>   		};
>> +
>> +		nand at 1ac00000 {
>> +			status = "ok";
>> +
>> +			pinctrl-0 = <&nand_pins>;
>> +			pinctrl-names = "default";
>> +
>> +			nand-ecc-strength = <4>;
>> +			nand-bus-width = <8>;
>> +		};
>>   	};
>>   };
>> +
>> +&adm_dma {
>> +	status = "ok";
>> +};
>
> I think the preference is to put the full path to the device in
> the dts file and then have status = "ok". So please move this
> into the soc node and give the correct offset, etc. like we've
> done for other nodes.

I'll do that.

Archit

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project