[PATCH 1/2] mtd: atmel_nand: remove pmecc_sector_number, use ecc.steps instead

Josh Wu josh.wu at atmel.com
Wed Sep 17 01:33:01 PDT 2014


Hi, Brian

Any feedback for this patch series?

Best Regards,
Josh Wu

On 8/8/2014 5:12 PM, Josh Wu wrote:
> For PMECC, the pmecc_sector_number has same meaning as ecc.steps.
> So use ecc.steps to replace the pmecc_sector_number.
>
> Signed-off-by: Josh Wu <josh.wu at atmel.com>
> ---
>   drivers/mtd/nand/atmel_nand.c | 14 ++++++--------
>   1 file changed, 6 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
> index 9c5f717..1dc3988 100644
> --- a/drivers/mtd/nand/atmel_nand.c
> +++ b/drivers/mtd/nand/atmel_nand.c
> @@ -129,7 +129,6 @@ struct atmel_nand_host {
>   	u32			pmecc_lookup_table_offset_1024;
>   
>   	int			pmecc_bytes_per_sector;
> -	int			pmecc_sector_number;
>   	int			pmecc_degree;	/* Degree of remainders */
>   	int			pmecc_cw_len;	/* Length of codeword */
>   
> @@ -874,7 +873,7 @@ static int pmecc_correction(struct mtd_info *mtd, u32 pmecc_stat, uint8_t *buf,
>   	return 0;
>   
>   normal_check:
> -	for (i = 0; i < host->pmecc_sector_number; i++) {
> +	for (i = 0; i < nand_chip->ecc.steps; i++) {
>   		err_nbr = 0;
>   		if (pmecc_stat & 0x1) {
>   			buf_pos = buf + i * host->pmecc_sector_size;
> @@ -984,7 +983,7 @@ static int atmel_nand_pmecc_write_page(struct mtd_info *mtd,
>   		cpu_relax();
>   	}
>   
> -	for (i = 0; i < host->pmecc_sector_number; i++) {
> +	for (i = 0; i < chip->ecc.steps; i++) {
>   		for (j = 0; j < host->pmecc_bytes_per_sector; j++) {
>   			int pos;
>   
> @@ -1031,7 +1030,7 @@ static void atmel_pmecc_core_init(struct mtd_info *mtd)
>   	else if (host->pmecc_sector_size == 1024)
>   		val |= PMECC_CFG_SECTOR1024;
>   
> -	switch (host->pmecc_sector_number) {
> +	switch (nand_chip->ecc.steps) {
>   	case 1:
>   		val |= PMECC_CFG_PAGE_1SECTOR;
>   		break;
> @@ -1184,18 +1183,17 @@ static int atmel_pmecc_nand_init_params(struct platform_device *pdev,
>   		host->pmecc_degree = (sector_size == 512) ?
>   			PMECC_GF_DIMENSION_13 : PMECC_GF_DIMENSION_14;
>   		host->pmecc_cw_len = (1 << host->pmecc_degree) - 1;
> -		host->pmecc_sector_number = mtd->writesize / sector_size;
>   		host->pmecc_bytes_per_sector = pmecc_get_ecc_bytes(
>   			cap, sector_size);
>   		host->pmecc_alpha_to = pmecc_get_alpha_to(host);
>   		host->pmecc_index_of = host->pmecc_rom_base +
>   			host->pmecc_lookup_table_offset;
>   
> -		nand_chip->ecc.steps = host->pmecc_sector_number;
>   		nand_chip->ecc.strength = cap;
>   		nand_chip->ecc.bytes = host->pmecc_bytes_per_sector;
> -		nand_chip->ecc.total = host->pmecc_bytes_per_sector *
> -				       host->pmecc_sector_number;
> +		nand_chip->ecc.steps = mtd->writesize / sector_size;
> +		nand_chip->ecc.total = nand_chip->ecc.bytes *
> +			nand_chip->ecc.steps;
>   		if (nand_chip->ecc.total > mtd->oobsize - 2) {
>   			dev_err(host->dev, "No room for ECC bytes\n");
>   			err_no = -EINVAL;




More information about the linux-mtd mailing list