[PATCH] nand: omap2: fix building with CONFIG_MTD_NAND_OMAP_BCH=m

[Roger Quadros]

On 10/01/2014 12:56 PM, Arnd Bergmann wrote:
> On Wednesday 01 October 2014 12:32:09 Roger Quadros wrote:
>>
>> With this patch NAND probe on DRA7xx fails like so
>>
>> [    2.077313] omap-gpmc 50000000.gpmc: GPMC revision 6.0
>> [    2.083842] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xca
>> [    2.090524] nand: Micron MT29F2G16ABAEAWP
>> [    2.094728] nand: 256MiB, SLC, page size: 2048, OOB size: 64
>> [    2.100745] nand: using OMAP_ECC_BCH8_CODE_HW ECC scheme
>> [    2.109764] omap2-nand: probe of omap2-nand.0 failed with error -38
>>
>> OMAP NAND driver is the only user of the ELM module and we want it
>> to be usable in all possible configurations when enabled.
> 
> I don't understand. Is the BCH driver optional or not?
> 
It is optional. If it is disabled we error out on platforms that have
the ELM IP. But if it is enabled, we don't want to fail probe on such platforms.

> The help text says:
> 
>           This config enables the ELM hardware engine, which can be used to
>           locate and correct errors when using BCH ECC scheme. This offloads
>           the cpu from doing ECC error searching and correction. However some
>           legacy OMAP families like OMAP2xxx, OMAP3xxx do not have ELM engine
>           so they should not enable this config symbol.
> 
> which adds more to the confusion. The help text sounds like everything should
> work even if ELM is disabled (which contradicts your finding above) but you
> must not enable the driver if you are on an older machine (which would
> break multiplatform builds).

I understand. We need to update that description. It is no longer the case that
we have to disable ELM engine to work on older platforms.

> 
>> Let's pick either one of the below patches instead
>>
>> http://article.gmane.org/gmane.linux.ports.arm.omap/118488
> 
> This doesn't let you have the BCH driver as a module, which seems
> wrong.
> 
>> http://article.gmane.org/gmane.linux.ports.arm.omap/118847
> 
> Looks good, although I think you can simplify this to
> 
> config MTD_NAND_OMAP_BCH_BUILD
> 	def_tristate MTD_NAND_OMAP2 && MTD_NAND_OMAP_BCH
> 
> which makes it 'm' if MTD_NAND_OMAP_BCH is set to m.

Right. I will resend this patch with this fixup
and update the Kconfig description as well.

cheers,
-roger