[PATCH 18/36] ARM: OMAP2+: gpmc-onenand: Move Synchronous setting code to drivers/

[Roger Quadros]

On 06/13/2014 10:55 AM, Tony Lindgren wrote:
> * Roger Quadros <rogerq at ti.com> [140611 01:59]:
>> Move the code that puts the onenand in synchronous mode
>> into the appropriate place i.e. drivers/mtd/onenand/omap2.c.
>>
>> Make use of omap_gpmc_get_clk_period() and omap_gpmc_retime()
>> to calculate the necessary timings and configure the GPMC
>> parent's timings.
> 
> Ideally we would just use the drivers/mtd/onenand/generic.c
> and get rid of drivers/mtd/onenand/omap2.c. We still need
> the bus glue, which should probably be in drivers/memory?
> 

But what about the runtime synchronous timing calculations onenand/omap2.c?
There is also OMAP2 and OMAP3 specific dma handling done there, which should probably be done generically using dmaengine.

cheers,
-roger