[PATCH] mtd: atmel_nand: make ecc parameters same as definition

Bo Shen voice.shen at atmel.com
Tue Jun 10 20:24:41 PDT 2014


Hi Josh,

On 06/09/2014 06:30 PM, Josh Wu wrote:
> Hi, Bo
>
> Thanks for the patch.
>
> On 6/6/2014 4:02 PM, Bo Shen wrote:
>> If the ecc parameter is not the same as definition, when the
>> mtd core check these parameters, it will give the unexpected
>> result.
> Could you be more specific to tell what kind of result will happened?

For example:
When try to calculate how many bits can correct in one page according to 
the definition, it will give the wrong result.

one page correct bits = (mtd->writesize * ecc->strength) / ecc->size;

take the following use case as an example:
mtd->writesize = 2048 bytes,
ecc->strength = 4 bytes, (for 512 bytes)

before this patch, the ecc->size = 2048, so the result is 4 bytes.

after this patch, the ecc->size = 512, so the result is 16 bytes.

The maximum correct bytes is 16 bytes while not 4 bytes. So, if not align

Best Regards,
Bo Shen



More information about the linux-mtd mailing list