[PATCH 1/2] mtd: nand: force NAND_CMD_READID onto 8-bit bus

[Brian Norris]

On Thu, Jan 30, 2014 at 09:17:04AM -0300, Ezequiel Garcia wrote:
> On Wed, Jan 29, 2014 at 02:18:28PM -0800, Brian Norris wrote:
> > The NAND command helpers tend to automatically shift the column address
> > for x16 bus devices, since most commands expect a word address, not a
> > byte address. The Read ID command, however, expects an 8-bit address
> > (i.e., 0x00, 0x20, or 0x40 should not be translated to 0x00, 0x10, or
> > 0x20).
> > 
> > This fixes the column address for a few drivers which imitate the
> > nand_base defaults. Note that I don't touch sh_flctl.c, since it already
> > handles this problem slightly differently (note its comment "READID is
> > always performed using an 8-bit bus").
> > 
> > I have not tested this patch, as I only have x8 parts up for testing at
> > this point. Hopefully that can change soon...
> > 
> > Signed-off-by: Brian Norris <computersforpeace at gmail.com>
> 
> I applied both patches and tested on my AM335x board (omap2-nand driver).
> Both 8-bit and 16-bit devices get ONFI-probed and pass a nandtest round.
> 
> Tested-by: Ezequiel Garcia <ezequiel.garcia at free-electrons.com>

Thanks for the quick testing!

> [..]
> > +
> > +/**
> > + * Check if the opcode's address should be sent only on the lower 8 bits
> > + * @command: opcode to check
> > + */
> > +static inline int nand_opcode_8bits(unsigned int command)
> > +{
> > +	return command == NAND_CMD_READID;
> > +}
> > +
> >  #endif /* __LINUX_MTD_NAND_H */
> 
> With the introduction of this function, I think all the problems we've
> discussed.

I think so too.

But I forgot to pose this question: are there any other commands which
should be treated similarly? NAND_CMD_PARAM only takes column address 0,
and I think Change Read Column (or NAND_CMD_RNDOUT, used for extended
parameter pages) takes a full buswidth address, according to the spec; I
suppose ONFI presumes the host has read the full parameter page and
determined the bus width by the time it wants to skip to the extended
parameter pages; or else it just continues to read out bytes
sequentially).

> The solution looks good to me so. Nice job!

Thanks. Glad to get it out of the way.

Brian