[RFC PATCH 1/9] mtd: nand: retrieve ECC requirements from Hynix READ ID byte 4

[boris brezillon]

Hello Brian,

On 23/01/2014 02:49, Brian Norris wrote:
> + Huang
>
> Hi Boris,
>
> On Wed, Jan 08, 2014 at 03:21:56PM +0100, Boris BREZILLON wrote:
>> The Hynix nand flashes store their ECC requirements in byte 4 of its id
>> (returned on READ ID command).
>>
>> Signed-off-by: Boris BREZILLON <b.brezillon at overkiz.com>
> I haven't verified yet (perhaps Huang can confirm?), but this may be
> similar to a patch Huang submitted recently. In his case, we found that
> this table is actually quite unreliable and is likely hard to maintain.

You mean these bytes are not reliable within the whole Hynix LP (Large Page)
NAND product line ?

>
> Why do you need this ECC information, for my reference?

Because the NAND flash available on the cubietruck board does not 
support the
ONFI standard, and I thought this could be a option to retrieve the ECC 
strength
requirements.

Anyway, I added a new helper function to retrieve ecc informations from 
device
tree (I'll post it in the 2nd version of this series). We'll see if this 
approach is
accepted...

>
> Brian