[PATCH] drivers: mtd: m25p80: Add quad read support.

[Sourav Poddar]

On Wednesday 25 September 2013 11:21 AM, Sourav Poddar wrote:
> On Wednesday 25 September 2013 11:18 AM, Huang Shijie wrote:
>> 于 2013年09月24日 20:10, Sourav Poddar 写道:
>>> +    flash->quad_read = false;
>>> +    if (spi->mode&&  SPI_RX_QUAD) {
>>> +        quad_enable(flash);
>>> +        flash->mtd._read = m25p80_quad_read;
>>> +        flash->quad_read = true;
>>> +    } else
>>> +        flash->mtd._read = m25p80_read;
>> How do you know the NOR support the QUAD read? by the spi->mode?
>>
>> i think you'd better add a DT node such as "m25p, quad-read".
> no need to add a new property, support is already there.
>
> If you see spi.c, "spi-rx-bus-width" property is already added. We 
> will set this
> property in dts to 4 in case of quad read. Once this is set, spi->mode 
> will
> be set to SPI_RX_QUAD in spi.c. which can be used by mtd layer to 
> device whether
Sorry for the 
typo..                                                                                 
^^^^
         
                                                                                                        decide
> flash supports quad read or not.
>>
>> thanks
>> Huang Shijie
>>
>
>
> ______________________________________________________
> Linux MTD discussion mailing list
> http://lists.infradead.org/mailman/listinfo/linux-mtd/