[PATCH v3 0/8] Add the Quadspi driver for vf610-twr

Gupta, Pekon pekon at ti.com
Thu Sep 12 06:56:14 EDT 2013


> > > Indeed - what I was wondering was if those opcodes could be requested
> > > from the flash driver rather than coded in there.  The driver needs to
> > > write the commands to the device but it's not clear to me if it really
> > > needs to know the specific commands.
> > yes. The driver uses the commands to find the _right_ LUT index, and
> > uses the LUT index to
> > trigger the controller.
> >
> > For example, LUT0-LUT3 is used for the READ_STATUS, the driver will
> > match the
> > 0 index for the NOR's read status operation (0x05), and then the driver
> > write 0 to the QSPI_IPCR
> > register to trigger the operation.
> 
> But why?
> 
> Your SPI controller's device driver gets a spi_transfer struct which
> (indirectly) comes from the m25p80 *chip* driver. That should contain
> appropriate values for tx_nbits and rx_nbits to indicate the mode which
> its to be used for this particular command.
> 
> All you need to do then is pick a suitable slot in the LUT table, *fill*
> the LUTn-LUN(n+3) registers with appropriate values, then write (n/4) to
> the QSPI_IPCR register. Or something like that? (Can you provide a URL
> for the datasheet for this controller?)
> 
> And if this is a command/nbits combination which has recently been used,
> of course you can skip the 'write the LUT registers' step and just use
> the same index you used last time. Add some LRU scheme to handle
> *which*
> index you use... handwave...
> 
Agree..
A minor update is required in m25p80_read() for different types of reads.
For taking examples mentioned earlier:
@@m25p80_read()
> > the read status only use a single line
	t[0].tx_buf = flash->command; /* read_opcode */
	t[0].len = m25p_cmdsz(flash) + (flash->fast_read ? 1 : 0);
+	t[0].tx_nbits = SPI_NBITS_SINGLE;  /* use single wire for this transfer */

> > , while the quad read uses 4 lines.
	t[0].tx_buf = flash->command; /* read_opcode */
	t[0].len = m25p_cmdsz(flash) + (flash->fast_read ? 1 : 0);
+	t[0].tx_nbits = SPI_NBITS_QUAD;  /* use single wire for this transfer */

'tx_nbits' and 'rx_nbits' are new fields added in struct *spi_transfer  for this
purpose only. Please refer below patch
 http://lists.infradead.org/pipermail/linux-mtd/2013-August/047995.html

So, this way master-driver (here mtd/../m25p80.c) can pass the info to
slave-driver (here spi/../qspi-controller.c), on how to send flash specific
commands and opcodes, by embedding that info in spi_transfer.

And when the spi_transfer reaches spi/.../qspi-controller.c driver, then
you can populate your LUT with info present in spi_transfer. And initiate
the actual transfer on SPI bus.

Am I missing something here ?
(David please correct me if I'm wrong in above explanation)

with regards, pekon


More information about the linux-mtd mailing list