[PATCH v10 03/10] mtd: nand: omap: cleanup: replace local references with generic framework names
Pekon Gupta
pekon at ti.com
Sat Oct 19 01:44:07 PDT 2013
This patch updates following in omap_nand_probe() and omap_nand_remove()
- replaces "info->nand" with "nand_chip" (struct nand_chip *nand_chip)
- replaces "info->mtd" with "mtd" (struct mtd_info *mtd)
- white-space and formatting cleanup
Signed-off-by: Pekon Gupta <pekon at ti.com>
---
drivers/mtd/nand/omap2.c | 112 ++++++++++++++++++++++++-----------------------
1 file changed, 57 insertions(+), 55 deletions(-)
diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c
index 8d521aa..5596368 100644
--- a/drivers/mtd/nand/omap2.c
+++ b/drivers/mtd/nand/omap2.c
@@ -1824,10 +1824,12 @@ static int omap_nand_probe(struct platform_device *pdev)
{
struct omap_nand_info *info;
struct omap_nand_platform_data *pdata;
+ struct mtd_info *mtd;
+ struct nand_chip *nand_chip;
int err;
int i, offset;
- dma_cap_mask_t mask;
- unsigned sig;
+ dma_cap_mask_t mask;
+ unsigned sig;
struct resource *res;
struct mtd_part_parser_data ppdata = {};
@@ -1846,17 +1848,16 @@ static int omap_nand_probe(struct platform_device *pdev)
spin_lock_init(&info->controller.lock);
init_waitqueue_head(&info->controller.wq);
- info->pdev = pdev;
-
+ info->pdev = pdev;
info->gpmc_cs = pdata->cs;
info->reg = pdata->reg;
-
- info->mtd.priv = &info->nand;
- info->mtd.name = dev_name(&pdev->dev);
- info->mtd.owner = THIS_MODULE;
-
- info->nand.options = pdata->devsize;
- info->nand.options |= NAND_SKIP_BBTSCAN;
+ mtd = &info->mtd;
+ mtd->priv = &info->nand;
+ mtd->name = dev_name(&pdev->dev);
+ mtd->owner = THIS_MODULE;
+ nand_chip = &info->nand;
+ nand_chip->options = pdata->devsize;
+ nand_chip->options |= NAND_SKIP_BBTSCAN;
#ifdef CONFIG_MTD_NAND_OMAP_BCH
info->of_node = pdata->of_node;
#endif
@@ -1877,16 +1878,16 @@ static int omap_nand_probe(struct platform_device *pdev)
goto out_free_info;
}
- info->nand.IO_ADDR_R = ioremap(info->phys_base, info->mem_size);
- if (!info->nand.IO_ADDR_R) {
+ nand_chip->IO_ADDR_R = ioremap(info->phys_base, info->mem_size);
+ if (!nand_chip->IO_ADDR_R) {
err = -ENOMEM;
goto out_release_mem_region;
}
- info->nand.controller = &info->controller;
+ nand_chip->controller = &info->controller;
- info->nand.IO_ADDR_W = info->nand.IO_ADDR_R;
- info->nand.cmd_ctrl = omap_hwcontrol;
+ nand_chip->IO_ADDR_W = nand_chip->IO_ADDR_R;
+ nand_chip->cmd_ctrl = omap_hwcontrol;
/*
* If RDY/BSY line is connected to OMAP then use the omap ready
@@ -1896,26 +1897,26 @@ static int omap_nand_probe(struct platform_device *pdev)
* device and read status register until you get a failure or success
*/
if (pdata->dev_ready) {
- info->nand.dev_ready = omap_dev_ready;
- info->nand.chip_delay = 0;
+ nand_chip->dev_ready = omap_dev_ready;
+ nand_chip->chip_delay = 0;
} else {
- info->nand.waitfunc = omap_wait;
- info->nand.chip_delay = 50;
+ nand_chip->waitfunc = omap_wait;
+ nand_chip->chip_delay = 50;
}
switch (pdata->xfer_type) {
case NAND_OMAP_PREFETCH_POLLED:
- info->nand.read_buf = omap_read_buf_pref;
- info->nand.write_buf = omap_write_buf_pref;
+ nand_chip->read_buf = omap_read_buf_pref;
+ nand_chip->write_buf = omap_write_buf_pref;
break;
case NAND_OMAP_POLLED:
- if (info->nand.options & NAND_BUSWIDTH_16) {
- info->nand.read_buf = omap_read_buf16;
- info->nand.write_buf = omap_write_buf16;
+ if (nand_chip->options & NAND_BUSWIDTH_16) {
+ nand_chip->read_buf = omap_read_buf16;
+ nand_chip->write_buf = omap_write_buf16;
} else {
- info->nand.read_buf = omap_read_buf8;
- info->nand.write_buf = omap_write_buf8;
+ nand_chip->read_buf = omap_read_buf8;
+ nand_chip->write_buf = omap_write_buf8;
}
break;
@@ -1944,8 +1945,8 @@ static int omap_nand_probe(struct platform_device *pdev)
err);
goto out_release_mem_region;
}
- info->nand.read_buf = omap_read_buf_dma_pref;
- info->nand.write_buf = omap_write_buf_dma_pref;
+ nand_chip->read_buf = omap_read_buf_dma_pref;
+ nand_chip->write_buf = omap_write_buf_dma_pref;
}
break;
@@ -1980,8 +1981,8 @@ static int omap_nand_probe(struct platform_device *pdev)
goto out_release_mem_region;
}
- info->nand.read_buf = omap_read_buf_irq_pref;
- info->nand.write_buf = omap_write_buf_irq_pref;
+ nand_chip->read_buf = omap_read_buf_irq_pref;
+ nand_chip->write_buf = omap_write_buf_irq_pref;
break;
@@ -1994,16 +1995,16 @@ static int omap_nand_probe(struct platform_device *pdev)
/* select the ecc type */
if (pdata->ecc_opt == OMAP_ECC_HAM1_CODE_HW) {
- info->nand.ecc.bytes = 3;
- info->nand.ecc.size = 512;
- info->nand.ecc.strength = 1;
- info->nand.ecc.calculate = omap_calculate_ecc;
- info->nand.ecc.hwctl = omap_enable_hwecc;
- info->nand.ecc.correct = omap_correct_data;
- info->nand.ecc.mode = NAND_ECC_HW;
+ nand_chip->ecc.bytes = 3;
+ nand_chip->ecc.size = 512;
+ nand_chip->ecc.strength = 1;
+ nand_chip->ecc.calculate = omap_calculate_ecc;
+ nand_chip->ecc.hwctl = omap_enable_hwecc;
+ nand_chip->ecc.correct = omap_correct_data;
+ nand_chip->ecc.mode = NAND_ECC_HW;
} else if ((pdata->ecc_opt == OMAP_ECC_BCH4_CODE_HW) ||
(pdata->ecc_opt == OMAP_ECC_BCH8_CODE_HW)) {
- err = omap3_init_bch(&info->mtd, pdata->ecc_opt);
+ err = omap3_init_bch(mtd, pdata->ecc_opt);
if (err) {
err = -EINVAL;
goto out_release_mem_region;
@@ -2013,9 +2014,9 @@ static int omap_nand_probe(struct platform_device *pdev)
/* DIP switches on some boards change between 8 and 16 bit
* bus widths for flash. Try the other width if the first try fails.
*/
- if (nand_scan_ident(&info->mtd, 1, NULL)) {
- info->nand.options ^= NAND_BUSWIDTH_16;
- if (nand_scan_ident(&info->mtd, 1, NULL)) {
+ if (nand_scan_ident(mtd, 1, NULL)) {
+ nand_chip->options ^= NAND_BUSWIDTH_16;
+ if (nand_scan_ident(mtd, 1, NULL)) {
err = -ENXIO;
goto out_release_mem_region;
}
@@ -2024,25 +2025,25 @@ static int omap_nand_probe(struct platform_device *pdev)
/* rom code layout */
if (pdata->ecc_opt == OMAP_ECC_HAM1_CODE_HW) {
- if (info->nand.options & NAND_BUSWIDTH_16)
+ if (nand_chip->options & NAND_BUSWIDTH_16) {
offset = 2;
- else {
+ } else {
offset = 1;
- info->nand.badblock_pattern = &bb_descrip_flashbased;
+ nand_chip->badblock_pattern = &bb_descrip_flashbased;
}
- omap_oobinfo.eccbytes = 3 * (info->mtd.writesize / 512);
+ omap_oobinfo.eccbytes = 3 * (mtd->writesize / 512);
for (i = 0; i < omap_oobinfo.eccbytes; i++)
omap_oobinfo.eccpos[i] = i+offset;
omap_oobinfo.oobfree->offset = offset + omap_oobinfo.eccbytes;
- omap_oobinfo.oobfree->length = info->mtd.oobsize -
+ omap_oobinfo.oobfree->length = mtd->oobsize -
(offset + omap_oobinfo.eccbytes);
- info->nand.ecc.layout = &omap_oobinfo;
+ nand_chip->ecc.layout = &omap_oobinfo;
} else if ((pdata->ecc_opt == OMAP_ECC_BCH4_CODE_HW) ||
(pdata->ecc_opt == OMAP_ECC_BCH8_CODE_HW)) {
/* build OOB layout for BCH ECC correction */
- err = omap3_init_bch_tail(&info->mtd);
+ err = omap3_init_bch_tail(mtd);
if (err) {
err = -EINVAL;
goto out_release_mem_region;
@@ -2050,16 +2051,16 @@ static int omap_nand_probe(struct platform_device *pdev)
}
/* second phase scan */
- if (nand_scan_tail(&info->mtd)) {
+ if (nand_scan_tail(mtd)) {
err = -ENXIO;
goto out_release_mem_region;
}
ppdata.of_node = pdata->of_node;
- mtd_device_parse_register(&info->mtd, NULL, &ppdata, pdata->parts,
+ mtd_device_parse_register(mtd, NULL, &ppdata, pdata->parts,
pdata->nr_parts);
- platform_set_drvdata(pdev, &info->mtd);
+ platform_set_drvdata(pdev, mtd);
return 0;
@@ -2080,9 +2081,10 @@ out_free_info:
static int omap_nand_remove(struct platform_device *pdev)
{
struct mtd_info *mtd = platform_get_drvdata(pdev);
+ struct nand_chip *nand_chip = mtd->priv;
struct omap_nand_info *info = container_of(mtd, struct omap_nand_info,
mtd);
- omap3_free_bch(&info->mtd);
+ omap3_free_bch(mtd);
if (info->dma)
dma_release_channel(info->dma);
@@ -2093,8 +2095,8 @@ static int omap_nand_remove(struct platform_device *pdev)
free_irq(info->gpmc_irq_fifo, info);
/* Release NAND device, its internal structures and partitions */
- nand_release(&info->mtd);
- iounmap(info->nand.IO_ADDR_R);
+ nand_release(mtd);
+ iounmap(nand_chip->IO_ADDR_R);
release_mem_region(info->phys_base, info->mem_size);
kfree(info);
return 0;
--
1.8.1
More information about the linux-mtd
mailing list