[PATCH 11/17] spi/qspi: set "mmap" flag to true.

[Sourav Poddar]

Set mmap flag to true to indicate that the qspi controller
supports memory mapped operations.

Signed-off-by: Sourav Poddar <sourav.poddar at ti.com>
---
 drivers/spi/spi-ti-qspi.c |    1 +
 1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/drivers/spi/spi-ti-qspi.c b/drivers/spi/spi-ti-qspi.c
index 10bcb37..d21d40d 100644
--- a/drivers/spi/spi-ti-qspi.c
+++ b/drivers/spi/spi-ti-qspi.c
@@ -532,6 +532,7 @@ static int ti_qspi_probe(struct platform_device *pdev)
 	master->configure_from_slave = ti_qspi_configure_from_slave;
 	master->get_buf = ti_qspi_get_mem_buf;
 	master->put_buf = ti_qspi_put_mem_buf;
+	master->mmap = true;
 
 	if (!of_property_read_u32(np, "num-cs", &num_cs))
 		master->num_chipselect = num_cs;
-- 
1.7.1