[PATCH v4 15/31] mtd: nand: pxa3xx: Use a completion to signal device ready

Brian Norris computersforpeace at gmail.com
Thu Nov 14 13:39:23 EST 2013


On Thu, Nov 07, 2013 at 12:17:19PM -0300, Ezequiel Garcia wrote:
> --- a/drivers/mtd/nand/pxa3xx_nand.c
> +++ b/drivers/mtd/nand/pxa3xx_nand.c
> @@ -863,21 +867,28 @@ static int pxa3xx_nand_waitfunc(struct mtd_info *mtd, struct nand_chip *this)
>  {
>  	struct pxa3xx_nand_host *host = mtd->priv;
>  	struct pxa3xx_nand_info *info = host->info_data;
> +	int ret;
> +
> +	/* Need to wait? */
> +	if (!info->is_ready) {
> +		ret = wait_for_completion_timeout(&info->dev_ready,
> +				CHIP_DELAY_TIMEOUT);
> +		if (!ret) {
> +			dev_err(&info->pdev->dev, "Ready time out!!!\n");
> +			return NAND_STATUS_FAIL;
> +		}
> +		info->is_ready = 1;

Shouldn't the is_ready=1 line to be above the if (!ret) condition? I
think you want to set is_ready=1 in either case (success or timeout).
With this code, any timeout will cause subsequent waitfunc()'s to block,
even if they are never going to catch an interrupt.

I think this kind of mistake is easier to make now, since the 'is_ready'
field isn't properly descriptive any more. It doesn't represent "is the
device ready"; it represents "is there a pending command on which I need
to wait". (I don't care if you change the name; I'm just pointing this
out.)

> +	}
>  

I think all the other patches up to this one are good. I may push them
to l2-mtd.git now, unless you object.

Brian



More information about the linux-mtd mailing list