[PATCH v2 3/5] mtd: nand: omap2: Fix OMAP_BCH option dependency

[Ezequiel Garcia]

On Fri, Oct 25, 2013 at 11:26:06AM +0000, Gupta, Pekon wrote:
> > From: Ezequiel Garcia [mailto:ezequiel.garcia at free-electrons.com]
> > Subject: [PATCH v2 3/5] mtd: nand: omap2: Fix OMAP_BCH option
> > dependency
> > 
> > This option does not need to depend in MTD_NAND, for it's enclosed
> > under it. Also, it's wrong to make it depend in ARCH_OMAP3 only
> > since the controller is used in a wider range of SoCs.
> > 
> > Instead, just leave the dependency on the OMAP2 driver option.
> > 
> > Signed-off-by: Ezequiel Garcia <ezequiel.garcia at free-electrons.com>
> > ---
> >  drivers/mtd/nand/Kconfig | 2 +-
> >  1 file changed, 1 insertion(+), 1 deletion(-)
> > 
> > diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
> > index d885298..8187466 100644
> > --- a/drivers/mtd/nand/Kconfig
> > +++ b/drivers/mtd/nand/Kconfig
> > @@ -95,7 +95,7 @@ config MTD_NAND_OMAP2
> >  	  platforms.
> > 
> >  config MTD_NAND_OMAP_BCH
> > -	depends on MTD_NAND && MTD_NAND_OMAP2 && ARCH_OMAP3
> > +	depends on MTD_NAND_OMAP2
> >  	tristate "Enable support for hardware BCH error correction"
> >  	default n
> >  	select BCH
> > --
> > 1.8.1.5
> 
> Acked-by: Pekon Gupta <pekon at ti.com>

Brian,

I almost forgot about this one, and I just came across the issue
while configuring my board.

I believe this one is simple enough to be pulled in for v3.14
(it could be in v3.13, but it's already too late).

Or maybe you're not taking stuff for v3.14 yet...
-- 
Ezequiel García, Free Electrons
Embedded Linux, Kernel and Android Engineering
http://free-electrons.com